Summary of Contents for HYPER TOY COMPANY Mercedes-Benz AMG GT3
Page 1
Mercedes-Benz AMG GT3 12V Ride-On Vehicle Instruction Manual Call us Toll-Free at 1-866-204-9737 for assistance and information from our trained staff. For product related questions or custom service needs please email info@hypertoys.com VISIT US ONLINE @ www.hypertoys.com 1 RIDER 30 KG, (66 LBS).
Page 2
Mercedes-Benz AMG GT3 12V Ride-On Vehicle Instruction Manual MAX WEIGHT 66 LBS, (30 KG) MAX WEIGHT: 30 KG (66 LBS) MAX RIDERS: 1 MAX SPEED: 5.6 KPH (3.5 MPH) FORWARD HIGH Protective equipment 3.2 KPH (2 MPH) FORWARD LOW should be worn.
Page 3
Table of Contents Important Information Safety, Warnings and Cautions Riding Safely Battery Charging Vehicle Operation Parts Assembly 10-14 Vehicle Care Troubleshooting Guide Limited Warranty IMPORTANT INFORMATION ADULT ASSEMBLY AND SUPERVISION REQUIRED. The battery must be charged for 8 to 12 hours before first use. To start charging the battery before starting assembly, see Battery Charging and Installation Information on page 4.
Warnings and Cautions WARNING: Electrical Hazard Only use a Hyper Toy Co. 12V lead-acid battery with this vehicle. Only use a Hyper Toy Co. Input AC 110-240V, (50-60Hz), Output DC 12V/1A charger. WARNING: Riding Hazard To reduce te risk of injury, adult supervision is required. Never use in roadways, near motor vehicles.
Rider Safety WARNING: Adult Supervision Required Only use the supplied rechargeable battery and charger with this electric ride-on vehicle. WARNING: Safe Riding Rules To reduce the risk of injury adult supervision is required. Always sit only on the seat in the vehicle. No more than one rider at a time.
ATTENTION! Only use the provided charger and battery from the original manufacture to charge this ride-on vehicle. For safety purpose all battery charging should only be done by an adult. Battery Disposal Electrical Run Time Power The battery will eventually lose the Outlet After Charging: ability to hold a charge.
When the battery runs out of electricity it must be charged immediately. Leaving the battery uncharged for too long will shorten it’s life. Even when the battery is not in use it should be charged at least once a month. During the charging process the battery charger or battery may feel slightly heated, if not the charger set, battery, or fuse has malfunctioned and my need to be replaced.
ATTENTION! An adult must be present at all times while children operate this ride-on vehicle. Make sure the child knows how to operate this ride-on vehicle safely and responsibly. ON/OFF Switch Forward/ Reverse Switch Light ON/OFF Switch Foot Pedal Accelorator 1.
Remote Control ATTENTION! This remote control should only be used by an adult. While learning to use this remote it’s best to not have a rider in the ride-on vehicle until you are familiar with the remote control. Remote Control Battery Install Make sure the ride-on vehicle is in the Back of Remote Control OFF Power mode.
ATTENTION! Assembly of this ride-on vehicle must always be performed by an adult. Keep children under the age of 3 years old away while assembling this ride-on vehicle. The small parts or plastic bags may become a choking hazard for children. 1.
Page 13
3. Connect Battery Cables Inside the ride-on cab, where the seat would be, you will find the battery cable connections as shown. Connect the battery cable connections by correctly aligning and pressing together the plastic terminals until a secure connection is made. Note: be careful not to damage the plastic terminals while pressing together. Turn the Power Switch to the ON mode to test the battery connection.
6. Windshield Installation Locate the windshield and align the windshield slot in front of the dash. Carefully press the windshield down, left, right, and center top edges, into the windshield slot so the windshield tabs engage and lock the windshield securely to the ride-on vehicles body.
8. Seat Installation Locate and remove the seat screw and from Seat the ride-on vehicle body as shown. Locate the Screw seat and align the seat support tabs with the seat support slots on the ride-on vehicles body as shown. Insert the seat fully into the ride-on vehicles body.
Page 16
10. Rear Wing Installation Rear Screws Locate and remove the 4 screws from the ride- Wing on vehicle Rear Wing and Base Supports as shown with a phillips screwdriver. Screws Base Supports 11. Rear Wing Installation Base Supports Align and insert the left and right Base Supports into the Rear Wing as shown.
Page 18
Problem Problem Cause Solutions contact customer service. contact customer service. Contact customer service. Contact customer service. contact customer service. contact customer service. Max weight is 66lbs, (30kg). contact customer service. “Dead Spots” on motor Contact customer service. Contact customer service. Contact customer service.
Page 19
Company electric Ride-On Toy. Should this Hyper Toy Company electric Ride-On toy or an part be determined defective by Hyper Toy Company to be covered by this Limited Warranty, it will be repaired or replaced, at Hyper Toy Company sole option, which will be conclusive and binding. Under no circumstances does this limited warranty include the cost of travel or shipment to and from any retailer or consumer.
Page 20
You will be able to find the product serial number on the underside of the vehicle. Hyper Toy Company For product related questions or Customer Service Contact: customer service needs please 177 Malaga Park Dr.
Need help?
Do you have a question about the Mercedes-Benz AMG GT3 and is the answer not in the manual?
Questions and answers