Advertisement
Quick Links
0. Before tour
●
Be sure to install compatible AA batteries before tour.
●
When low-battery signals show up, change batteries immediately.
1. Interface
2. Signal indicator
Status
TX
Green
Red
Steady
Device is on
Flash
Mic muted
slowly
Flash
Grouping
quickly
under process
Okayo WT-300D user manual
1.
Antenna
2.
Signal indicator
3.
Mic(TX)/Earphone(RX) jack
4.
Volume control
5.
Inbuilt mic (TX)
6.
Up/Down button (▲▼)
7.
Power button (
8.
Display
9.
Charging contacts
RX
Full power
Low power (< 10%)
In the group
-
-
)
Advertisement
Summary of Contents for MEXPO Okayo WT-300D
- Page 1 Okayo WT-300D user manual 0. Before tour ● Be sure to install compatible AA batteries before tour. ● When low-battery signals show up, change batteries immediately. 1. Interface Antenna Signal indicator Mic(TX)/Earphone(RX) jack Volume control Inbuilt mic (TX) Up/Down button (▲▼)
- Page 2 5. Changing the frequency Change the operating band if necessary The Okayo WT-300D device operates on the 863 ~ 865 MHz band by default. To operate on another band (B), 823 ~ 832 MHz, please follow the instructions below. 1. Press and hold ▲ to power on ( ).
- Page 3 3. New channel will be locked automatically when being idled for 5 seconds. 11. Power off Press to power any device off. 12. Service and distribution MEXPO +48 58 550 10 25 ul. Kazimierza Pułaskiego 8 www.systemtourguide.com 81-368 Gdynia biuro@systemtourguide.com...
Need help?
Do you have a question about the Okayo WT-300D and is the answer not in the manual?
Questions and answers