Zephyr RC-0003 Instructions

ZEPHYRONLINE.COM
Pairing the Remote Control
RC-0003 must be paired to enable RF remote control capabilities. To synchronize your hood and
remote control for the first time, please follow these steps:
For Current Models: DAP-M90Ax, DHZ-M90Ax, DLA-M90Ax, DLA-E42Ax, DME-M90Ax, DME-E48Ax,
DVL-E36Ax, DVL-E42Ax, DVS-E30Ax, DVS-E36Ax, ZPO-E30AS, and ZPO-E36AS
1. With the range hood off, press and hold the Power button on the hood for 4 seconds until the 3rd
speed indicator on the hood flashes 3 times.
2. Press any button on the remote control within 4 seconds to confirm the link. The range hood is
now synchronized with the remote control. If any problems are experienced, please repeat the
procedure. The hood lights will turn on if the Lights button on the remote control was pressed to
confirm the link.
For Previous Models: AIN-M80Ax, AWA-M90Ax, ADL-M90Bx, ADL-E42Bx, ADU-M90Bx, ALA-M90Bx,
ALA-E42Bx, ALL-M90Bx, ALL-E42Bx, and ALU-E43Ax
1. With the range hood off, press and hold the Power and Delay Off buttons on the remote for 4
seconds until the Delay Off indicator on the hood illuminates.
2. Press the Delay Off button on the hood within 4 seconds to confirm the link. If successful, the
Delay Off indicator on the hood will flash 3 times. The range hood is now synchronized with the
remote control. If any problems are experienced, please repeat the procedure.
NOTE: "x" within the model number represents a placeholder for different colors.
Installing the Battery
Please follow the steps below to install the battery. Visit our website, store.zephyronline.com, if a
replacement battery is needed. The battery part number is 15000014.
1. Remove the rubber
bottom.
MAY24.0201
2. Place a pen or
screwdriver in the
bottom opening to
dislodge the top
touch panel.
RC-0003 Instructions
3. Remove the top
touch panel from
the remote body.
4. Install (1) CR2032
battery and
reassemble the
remote body.