PRODUCT GRAPHICS
missing, painted over or can no longer be read.
Keep safety product graphics (decals) clean. Replace
Replacement safety graphics are available through
any safety graphic that is damaged, destroyed,
your dealer.
A CAUTION
LOOK!
BEFORE
BACKING
READ OPERATOR'S MANUAL. Learn to operate this machine SAFELY. Do not
risk serious injury or death.
1. Be familiar with controls before starting engine and operating.
Be in operator's position with transmission in neutral, PTO
switch OFF, and brake depressed.
2. Keep shields in place. Keep away from moving parts.
3. NO RIDERS! Keep all people and pets a safe distance away.
4. Don't point mower discharge at people.
5. Avoid slopes. Tractors can be rolled over.
6. Before leaving operator's position:
Shut off PTO. Place transmission in neutral. Set parking brake. Shut off engine.
Remove ignition key. Wait for all movement to stop before servicing or cleaning.
7. Do not fill fuel tank when engine is running. Tighten cap securely.
TURNING BRAKE INSTRUCTIONS
I
— BRAKE PEDAL LATCH
PEDALS LATCHED TOGETHER
• Latch brake pedals together
_<
SEPARATE
BRAKE PEDAL
except for tillage operation.
• Latch brake pedals together
for high gear or road travel.
/"
• Latch brake pedals together
before setting parking brake.
'
-
-
JK*8*
OPERATION
3494
j
GENERAL SAFETY INSTRUCTIONS CAUTION -
LOCATED ON THE FRAME COVER
A CAUTION
Electrical system is 12 volt negative ground. When using booster with jumper cables,
precautions must be taken to prevent personal injury or damage to electrical parts.
1. Attach one end of jumper cable to positive terminal of booster battery and other end
to positive terminal of vehicle battery.
2. Attach one end of second cable to negative terminal of booster battery and other end
to vehicle frame away from battery.
3. To remove cables, reverse above sequence exactly to avoid sparks. See operator's
manual for additional information.
CAUTION - BOOSTER BATTERY INSTRUCTIONS
LOCATED UNDERSIDE OF HOOD
5
Need help?
Do you have a question about the 1772 and is the answer not in the manual?