Hydro-Smart HSRadStatFlr User & Installation Manual

Application:
Hydronic Heating, Connections R,W,C to be connected to
Zone by Pump, Valve, Actuator Controllers
Specifications:
Power Supply: 24Vac 60Hz
Temperature Setting Range: + - 1 Deg F
Temperature Accuracy: + - 1 Deg F
Remote Sensor: NTC10K
Power Consumption: < 2 Watts
Grade of protection: IP 30
Installation Type: Surface Mount
User Guide:
On/Off:
Press power button
Temperature Setting:
Press "
temperature.
Mode:
Press "M" to change mode between cool
be confirmed by pressing other button or automatically after 6 seconds.
Fan:
Press " " to fan
when the room temperature reach the setpoint.
Backlight:
Any key press will activate the backlight. Backlights will timeout 6
seconds after last key press.
Keypad Lockout:
(Only available when item 11 set to (1),(2),(3) for 3 sec-
onds to lock the buttons and press "
Wiring Diagram:
Hydronic Controller
W
7 6 5 4 3
W
Thermostat
12 11 10 9 8
Floor Sensor
CE Standard EN60730-1
Manual Installation/User
(HSRadStatFlr) Non-Programmable
.
Humidity: 5-95%
Backlight: White
to switch ON and OFF thermostat.
" to reduce temperature "
, heat , mode will
(ON) or Auto (Auto), On means
" and " " for 3 seconds to unlock.
R C
2 1
R C
To remove remove display from base. Push
back base hooks and lift display for
removal.
www.hydro-smart.com
" to raise
To install install display to base. Position
display slots into base hooks then
rotate to snap into place.
Display
Base
Mounting and Installation:
Display
Base
Page 1 0f 2
Hydro Smart
72 72
F
M
Hydro Smart
Base
Mounting
Screws (2)
Base hooks (2)
Display
Base
BC105S-AC-D-24