NTI ST-C5MK-VESA Installation Instruction

ST-C5MK-VESA
VESA MOUNTING BRACKET KIT
Installation Instruction
The ST-C5MK-VESA is a VESA Mounting Bracket Kit that allows an NTI extender (XTENDEX) to be easily mounted to the back of a
flat panel monitor enabling simple and clean cable routing and saving valuable desk space.
two sets of mounting holes compliant to VESA 75mm and 100mm mounting hole patterns. Two sets of standoffs allow the NTI
XTENDEX to be attached such that cables can approach from any of 4 directions.
can be mounted using the ST-C5MK-VESA.
Compatible XTENDEX Models
ST-C5x-600: Remote Units only
ST-C5x-300: Remote and Local Units
ST-C5x-1000: Remote Units only
Installation
1. If the existing monitor support arm bracket (see picture on page 3 for reference) has not already been removed from the monitor,
remove it now.
2. Place the large ST-C5MK-VESA mounting bracket between the support arm bracket and the monitor.
arm bracket will line up with either the holes in the VESA 75mm pattern or the 100mm pattern (see image below). Reapply the screws
to secure the support arm bracket and the large ST-C5MK-VESA mounting bracket to the monitor.
securely.
Hole pattern for 100mm mounting
Hole pattern for
75mm mounting
Rear View of LCD monitor
Where to find:
http://www.networktechinc.com/cat5.html
http://www.networktechinc.com/cat5-vga.html
http://www.networktechinc.com/cat5-300.html
http://www.networktechinc.com/cat5-300-vga.html
http://www.networktechinc.com/cat5-1000.html
http://www.networktechinc.com/cat5-1000-vga.html
Place VESA mounting bracket between the monitor mounting
plate and the monitor.
the 100mm hole pattern.
1
The ST-C5MK-VESA is provided with
See the chart below for XTENDEX models that
The holes in the support
Be sure to tighten the screws
Use either the 75mm hole pattern or
Standoffs for mounting the XTENDEX