Download Print this page
Winco BENCHMARK USA 62010 Manual

Winco BENCHMARK USA 62010 Manual

Hot dog roller grill

Advertisement

Quick Links

H
H
Item No:
120V~60 Hz, 660W, 5.5A | 120~60 Hz, 860W, 7.2A | ~60 Hz, 1160W, 9.7A
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH.
WARNING: Handling the cord on this product may expose you to lead, a chemical known to the State of
California to cause cancer and birth defects or other reproductive harm. WASH HANDS AFTER HANDLING.
Electrical ground is required on this appliance.
1. Do not modify the power supply cord plug. If it does not fit the outlet, have a proper outlet
installed by a qualified electrician.
2. Do not use an extension cord with this appliance.
3. Check with a qualified electrician if you are in doubt as to whether the appliance is properly
grounded.
1. Plug electrical cord into a certified electrical outlet with a corresponding voltage rating as
listed on the machine model labels.
2. Always unplug the electric cord when appliance is not in use and before cleaning, adjusting
or maintaining this steamer. Do not operate with a damaged cord or plug or after the machine
malfunctions, has been dropped or damaged. Use authorized service for examination,
electrical or mechanical adjustment or repair.
3. This equipment will be HOT during use and for a short time after it is turned off. BE
CAREFUL. To avoid burns, do not let bare skin touch hot surfaces. If provided, use handles
when moving this appliance. Keep combustible materials away from appliance.
4. Extreme caution is necessary when any appliance is used by or near children and whenever
the appliance is left operating and unattended.
5. This appliance is not intended for use in wet locations. Never locate appliance where it may
fall into a water container.
Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may
cause an electrical shock, fire or damage to the appliance.
o
t
D
o
g
o
t
D
o
g
6
2
0
1
0
/
6
2
0
1
0
/
WARNING ELECTRICAL SHOCK HAZARD.
SAFETY INSTRUCTIONS
R
o
l
l
e
r
G
R
o
l
l
e
r
G
6
2
0
2
0
/
6
2
0
2
0
/
r
i
l
l
r
i
l
l
6
2
0
3
0
6
2
0
3
0

Advertisement

loading
Need help?

Need help?

Do you have a question about the BENCHMARK USA 62010 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Winco BENCHMARK USA 62010

  • Page 1 Item No: 120V~60 Hz, 660W, 5.5A | 120~60 Hz, 860W, 7.2A | ~60 Hz, 1160W, 9.7A WARNING ELECTRICAL SHOCK HAZARD. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. WARNING: Handling the cord on this product may expose you to lead, a chemical known to the State of California to cause cancer and birth defects or other reproductive harm.
  • Page 2 CLEANING SAFETY INSTRUCTIONS 1. Turn control off and unplug the power cord. Avoid splashing water onto control. 2. Do not clean this appliance with a water jet or immerse in water or other liquid. OPERATING INSTRUCTIONS 1. Plug the machine into a properly grounded 120 volt power supply. 2.
  • Page 3: Cleaning The Machine

    CLEANING THE MACHINE 1. At the end of day: Turn the machine off using the master switch. Remove any remaining hotdogs from the grill. 2. Turn on the rollers and set the thermostat to “OFF” setting. The rollers will now be rotating without any heat being applied.
  • Page 4: Wiring Diagram

    WIRING DIAGRAM...
  • Page 5 ASSEMBLY...
  • Page 6 PARTS Bottom Panel Chain Gear Heater Right Panel Left Panel Roller Seal Roller Tube Drip Tray Side Cover Right Heater Guide Left Heater Guide...
  • Page 7: Parts List

    PARTS LIST Bottom Panel Drive Chain Gear Heater Right Panel Left Panel Roller Seal Roller Tube Drip Tray Side Cover Right Heater Guide Left Heater Guide Thermostat Roller Switch Power Cord Strain Relief Rubber Foot Motor Base...

This manual is also suitable for:

Benchmark usa 62020Benchmark usa 62030