Operation; Before Using For The First Time - HOMCOM K538QNK Instruction Manual

● Never open the lid when the water is still boiling.
● Only water must be used in this appliance – do not use for other liquids.
● Fill the jug kettle with at least 0,5 litres of water.
● Before storing the appliance, allow it to cool to room temperature.
● Never use the appliance through an external timer or remote control.
This appliance is for domestic use only. It is not intended for commercial use.
Feature
1. Spout
2. Top lid
3. Lid handle
4. Handle
5. Body
6. Water-level indicator
7. Base
8. On/off switch with pilot light
Before using for the first time
Clean the kettle by filling it with water and bringing to a boil – do this three times,
disposing of the water each time.
Tip: When boiling for the first time, you can use vinegar or special descaling agents.
Use
1. Make sure the spout is facing away from you.
2. Pull up the lid handle (3) to open the lid (2).
3. Fill the jug with the required quantity of water (0.5-1.7 litres). Never fill water above the
'max' limit – hot water could spatter out.
ATTENTION!
Do not spill water on the base.
4. Close the lid.
5. Place the jug on the base, then insert the plug into the wall socket. Push the 'on/off'
switch – the 'on/off' light will illuminate.
6. The jug kettle is now switched on – the water will begin to heat. When the water has
come to a boil, the kettle will switch off automatically after a few seconds.
7. Using the handle, remove the jug from the base and pour the water out.
ATTENTION!
To prevent scalding, do not touch the hot water.
8. If you want to heat water without boiling it, you can switch the kettle off at any time.
9. When finished with the kettle, remove the plug from the wall socket.

Operation

3
1
5
7
3
2
4
6
8