Novus NDR Series Manual

Advertisement

NDR POWER SUPPLY
MODELS:
NDR-75-24,
NDR-120-24,
NDR240-24
USER GUIDE – V1.0x

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NDR Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Novus NDR Series

  • Page 1 NDR POWER SUPPLY MODELS: NDR-75-24, NDR-120-24, NDR240-24 USER GUIDE – V1.0x...
  • Page 2: Table Of Contents

    SAFETY ALERTS ................................... 3 PRESENTATION ..................................... 4 INSTALLATION ....................................5 ELECTRICAL INSTALLATION ..............................5 TECHNICAL SPECIFICATION ............................... 6 CERTIFICATIONS ................................... 7 WARRANTY ....................................8 NOVUS AUTOMATION...
  • Page 3: Safety Alerts

    Safety recommendations must be followed to ensure personal safety and prevent damage to the equipment or system. If the equipment is used in a manner other than that specified in this manual, the safety precautions may not be effective. NOVUS AUTOMATION...
  • Page 4: Presentation

    PRESENTATION The NDR Sources are available in three versions, differentiated by load current capacity: 3.13 A, 4 A and 10 A. They have the following features: Universal AC input • Protection against short circuits, overload, overvoltage, and overheating • Compatible with 7.5 or 15 mm TS-35 DIN rails •...
  • Page 5: Installation

    INSTALLATION ELECTRICAL INSTALLATION Electronic and analog signal conductors should run through the plant separately from the supply and load drive conductors. If possible, in • grounded conduits. The power supply for electronic instruments must come from a network specific to the instrumentation. •...
  • Page 6: Technical Specification

    2. The ripple and noise are measured at a bandwidth of 20 MHz, using a 12-inch twisted pair with a capacitor of 0.1 μ and 47 μ in parallel. 3. Tolerance: The equipment has a tolerance for the configuration process, line regulation, and load regulation. NOVUS AUTOMATION...
  • Page 7: Certifications

    4. The power supply is considered a component that will be installed in the final equipment. You must confirm that the final equipment complies with EMC standards. CERTIFICATIONS CE MARK This is a Class A product. In a domestic environment, this product may cause radio interference in which case the user may be required to take adequate measures. NOVUS AUTOMATION...
  • Page 8: Warranty

    WARRANTY Warranty conditions are available on our website www.novusautomation.com/warranty. NOVUS AUTOMATION...

This manual is also suitable for:

Ndr-75-24Ndr-120-24Ndr240-24

Table of Contents