CableTronix CT-STB-DVR-RC Setup Manual

Remote Control Setup Guide
1. Press and hold the "OK"(see
image on back #1) and "0"
buttons simultaneously for
3 seconds to enter learning
mode; the light will remain on.
If there is no activity within 10
seconds, or if you press and
hold "OK" and "0" again,
the light will turn off and exit
learning mode.
2. Press the Power button on the
TV control panel (see image
on back #2). The light will
flash once and then remain
steadily on.
3. Place the original TV remote
control and the CT-STB-DVR-RC
remote control 1-2 inches (3-5
cm) apart. Press the Power
button on the original TV
remote control. The light will
flash twice slowly and then
stay steadily on, indicating
that learning was successful.
4. Repeat steps 2 and 3 to
program additional buttons.
(see image on back #3, #4,)
• #3 Volume Buttons
• #4 TV Source Button
5. Once learning is complete,
press any button that was not
programmed, or remain inac-
tive for 10 seconds. The light
will flash twice and then turn
off, indicating that the data has
been saved and the system has
exited learning mode.
CT-STB-DVR-RC