Advertisement
Quick Links
Loose Parts
Note:
Use the chart below to identify parts used for assembly.
DESCRIPTION
Adapter
Screw #10-32 x 1/2" (13 mm)
Throttle cable
Choke cable
Install Cables
1.
Remove existing throttle and choke cables from
tractor (Fig. 1).
Note:
Save all hardware for use when
installing new cables.
2.
Observe location of boots on ends of new
throttle and choke cables. Remove boots.
3.
Remove jam nut from new choke cable (Fig. 1).
4.
Route throttle lever through rear of dash and
secure with screws previously removed. Press
knob onto throttle lever (Fig. 1).
5.
Route choke cable through front of dash and
secure with jam nut previously removed (Fig. 1).
CHOKE AND THROTTLE CABLES KIT
PART NO. 99-3745
QTY.
1
1
Install replacement cables
1
1
1
1. Throttle
2. Knob
FORM NO. 3321-592
INSTALLATION
INSTRUCTIONS
USE
2
4
m–4024
Figure 1
3. Choke
4. Jam nut
3
Advertisement
Related Manuals for Toro 99-3745
Summary of Contents for Toro 99-3745
- Page 1 FORM NO. 3321-592 CHOKE AND THROTTLE CABLES KIT INSTALLATION PART NO. 99-3745 INSTRUCTIONS Loose Parts Note: Use the chart below to identify parts used for assembly. DESCRIPTION QTY. Adapter Screw #10-32 x 1/2” (13 mm) Install replacement cables Throttle cable...
- Page 2 Align adapter so tabs are below engine cable 12. To adjust cables, move throttle lever to the bracket (Fig. 2). “FAST” position and pull the choke to the full “CHOKE” position. Secure adapter to engine cable bracket with new #10-32 x 1/2” (13 mm) screw (Fig. 2). 13.
Need help?
Do you have a question about the 99-3745 and is the answer not in the manual?
Questions and answers