Bluesky Telemaster 120 Assembly Instructions

ASSEMBLY INSTRUCTIONS
Hello friend! You are about to try a new way of assembling kits. Much easier and
faster. However, we need to pay attention to some guidelines to facilitate our assembly:
1- all indications engraved on each piece must always be visible;
2- they must always be facing forward, in the case of horizontal and outward in the
case of vertical;
3- the fittings are accurate, but if there is a need for any adjustment, do it;
4- do not glue definitively before making sure it is in the correct way, so assemble
the parts before gluing them;
5- you will need sandpaper of various thickness, CA glue and / or wood, in addition
to epoxy;
6- all assembly is illustrated on the A1 format sheet with this kit. The guidelines that
may not be there, will be here.
Knowing all the guidance presented, we will start the work. Good assembly and good
flights!
VERTICAL STABILIZER:
- let's start with the easiest one, the vertical stabilizer. Find piece R1 and glue it
together with R2, R3 and R4. End with R5. The moving part, R6, is one-piece. R7 will only
be glued after the model has been covered. Separate it.
HORIZONTAL STABILIZER:
-in the same way, join pieces E1, E2 and E3. Locking the structure, glue E4 as
shown in the illustration. Finish with parts E5 and E6. Ready! The control surface is also a
one-piece E7. Finished!
CANOPY:
-very simple. With the two pieces H3, glue the surfaces H1 and H2. But first, these
two need to have their internal edges chamfered in order to promote a perfect fit between
them. Glue the MAG piece to the magnet region and H4 aligns with the hole in C1. Both
operations must be done after the fuselage is ready.