Blue Mark DB150 Quick Start

QUICK START
(rev 20240527)
Attach to the drone
Attach the db150 on the top of
your drone:
Use the 3M dual lock™

stickers (included).
And/or use two M5 screws.

Use the db150
Power on the db150.

 Wait for the status LED to
signal Ready for take-off.
You are ready to fly.

Status LEDs
e e e
Ready for take-off: slowly
flashing (every 4s), location acq.
e
Non-compliant config: very slow
flashing (every 20s), location acq.
e e l e e l e e
Acquiring location. LEDs are on.
Battery level is the color of the LED
(full: green, almost empty: red)
Charging
Charge
Charge the db150 using a USB-C
Charge the db120 using a USB-C
time
charger. Charging LED blinks
charger. Charging LED turns
during charging. Full, LED is on.
green if fully charged.
Configuration
time
No configuration is required for
Configuration
USA. Configure operator ID for EU
No configuration is required for
use.
USA. Press configuration button
Press configuration button (status
and connect to dronebeacon
time
LED is now white) and connect to
WLAN network. Point your
dronebeacon WLAN network. Point
browser to http://192.168.50.1
your browser to
http://192.168.50.1