Modern Forms XF-SCK Series Assembly Instructions

ASSEMBLY INSTRUCTIONS
For 45° SLOPED CEILING ADAPTOR
READ AND SAVE THESE INSTRUCTIONS
A) Mounting plate
B) Canopy
C) Downrod ball
ASSEMBLY
REMEMBER TO TURN OFF POWER BEFORE BEGINNING
INSTALLATION
A. To reduce the risk of electric shock, insure electricity
has been turned off at the circuit breaker or fuse box
before beginning.
B. WARNING: To reduce the risk of personal injury, use
only the two steel screws (and lock washers) provided
with the outlet box for mounting to the outlet box.
Most outlet boxes commonly used for the support of
lighting fixtures are not acceptable for fan support
and may need to be replaced, consult a qualified
electrician if in doubt.
C. The outlet box and support structure must be
securely mounted and capable of reliably supporting
a minimum of 50 pounds. Use only UL Listed outlet
boxes marked "Acceptable for Fan Support of 15.9 kg
(35 lbs) or Less".
D. This unit accommodates slopes of up to 45 degrees.
1. Install mounting plate to outlet box in ceiling using
the screws and washers provided with your outlet
box. Remove the two canopy mounting screws 180
degrees apart on outside edge of mounting plate.
Loosen the 2 remaining screws. This will make
installation of the canopy easier in step 5 & 6. (Fig. 1)
2. Remove the downrod ball that was supplied with
your ceiling fan by loosening the two set screws. Slide
the downrod ball off the downrd. Be sure to keep the
crosspin supplied with your fans downrod to use with
the slope ceiling adapter ball. (Fig. 2)
3. Carefully feed the motor wires and safety cable up
through the downrod. Thread the downrod into the
collar. Align the holes of downrod and collar and
insert the cotter pin and clevis pin. Tighten the two
collar screws. (Fig. 3)
PARTS
A
Fig. 1
Cross pin
Set screw
Fig. 2
Motor wires
Downrod
Collar
Clevis pin
Fig. 3
MODEL: XF-SCK-xx
B C
Set screw
Safety cable
Screws (2)
Cotter pin