Gecko HARWIN HRi Series Instruction Sheet

Hide thumbs

page of 8

/ 8
Bookmarks

Quick Links

Download this manual

Instruction Sheet

IS-45

Assembly Procedure for Gecko-SL Metal Backshells

// HARWIN.COM

Need help?

Do you have a question about the HARWIN HRi Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Gecko HARWIN HRi Series

Page 1 Instruction Sheet IS-45 Assembly Procedure for Gecko-SL Metal Backshells // HARWIN.COM...
Page 2 – Gecko-SL Male single-ended cable assemblies  G125-MCxxx05M1-xxxxM1 – Gecko-SL Male double-ended cable assemblies  The metal backshells can also be fitted to the Gecko-MT housings and cable assemblies with the same screw-lok variations.  G125-2249600-01-08-01 – Gecko-MT Female crimp housings, no screw-loks (equivalent to 16-contact Gecko-SL) ...
Page 3 IS-45 Instruction Sheet for Gecko-SL Metal Backshells PREPARATION Please consult the “Applicable Backshell products” to confirm the correct backshell kit is selected for the required connector gender. This instruction sheet uses assembly of to a G125-96416F1 ready-made cable assembly as an example.
Page 4: Assembly Method
The instructions also cover the copper braid being assembled, which provides EMC shielding, wear prevention and cable management. 1. Take one half of the Gecko backshell and lay flat as shown on a clean working surface. Note: Pay attention to the slot highlighted in as this is important in step 2.
Page 5 IS-45 Instruction Sheet for Gecko-SL Metal Backshells 3. Insert both jackscrews supplied in the kit from the rear of the connector and lay into the groove in the backshell as shown. 4. Place the second side of the backshell over the assembly.
Page 6 IS-45 Instruction Sheet for Gecko-SL Metal Backshells Adding Braid (if required) 1. Feed braiding over the wire and push up to the second ridge on the cable exit of the backshell as shown. Note: tape over the end of the loose cables may assist with this operation.
Page 7 IS-45 Instruction Sheet for Gecko-SL Metal Backshells 6. Position the buckle of the micro-band in the center of the two ridges of the backshell cable exit. Note: Rotate the buckle of the band-it tie to orientated on the longest side of centrally the backshell as shown.
Page 8 Instruction Sheet for Gecko-SL Metal Backshells OTHER ASSEMBLY OPTIONS The Gecko metal backshell range is expected to be used with metal braid, for EMC/RFI purposes. However, it is also possible to use polymer and glass-fibre braid types, depending on the desired result and application.

This manual is also suitable for:

Harwin is-45