Advertisement
INVICTA
Invicta Touch Interface
SNLXMTSOC - Manual
SPB Sydney Office: 2/28 Prime Drive, Seven Hills New South Wales, 2147
SPB Melbourne Office: 3/35 Dunlop Road, Mulgrave, Melbourne, VIC, 3170
SPB National Head Office: 1 Ant Road, Yatala, Brisbane, QLD 4207
T
1300 001 772
E
info@spb.net.au
LITHIUM
BATTERIES
W
spb.net.au
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Invicta SNLXMTSOC
- Page 1 LITHIUM BATTERIES Invicta Touch Interface SNLXMTSOC - Manual SPB Sydney Office: 2/28 Prime Drive, Seven Hills New South Wales, 2147 SPB Melbourne Office: 3/35 Dunlop Road, Mulgrave, Melbourne, VIC, 3170 SPB National Head Office: 1 Ant Road, Yatala, Brisbane, QLD 4207 1300 001 772 info@spb.net.au...
- Page 2 Based on RS485 communication, it provides detailed information on battery status, including voltage, current, remaining capacity, temperature, and configuration settings. Unlike traditional setups that require a connection to the diverter, Invicta Interface can be directly linked to the battery using a simple wiring harness. This streamlined connection method not only reduces the cost of the wiring harness but also significantly speeds up the installation process.
-
Page 3: Specifications
CAN/RS485/RS232 communication • IP65 water and dust resistant front with rubber gasket seperator • Directly connectable to Invicta Xero batteries or via the Invicta I-Hub. • Features a 5.0-inch IPS LCD screen with 800x480 pixel resolution and 262K true-color display. •... -
Page 4: Battery Setup
Connect Communication Cable: Connect the communication cable to the LINK IN port of the Invicta Xero or the Invicta Interface port of the INVICTA I-HUB (if applicable). Verify that the INVICTA I-HUB power and communication cables are properly connected to the Invicta Xero. -
Page 5: Installation
INVICTA LITHIUM BATTERIES Installation Housing Requirements • Rubber gasket will be black. Ensure nothing is obstructing the seal as this is a protection for internals of the device. • Minimum opening requirement (mm) 107H x 149W x 18.5D • Maximum requirement should not exceed external dimensions of unit •... - Page 6 INVICTA LITHIUM BATTERIES Installation Screw Adjustment • Loosen the screw 90 in anti-clockwise direction, the clip will be in horizontal position • Rotate clip 90 in clockwise direction until in vertical position • Lock the 4 screws to fix the product on the housing...
-
Page 7: Screen Display
INVICTA LITHIUM BATTERIES Screen Display Parameter Page Detail Page • SOC: The state of charge, displayed as a • Voltage (V): The voltage of the chosen percentage. When the SOC is not greater pack. than 10%, the interface will change from •... - Page 8 LITHIUM BATTERIES Screen Display Setting Page • Time Setting: Invicta Touch Interface has RTC, including year, month, day, hour, minute, and second. It is possible to modify the time through the setting interface. It must click confirm after completing the time setting.
-
Page 9: Warning Alarms
INVICTA LITHIUM BATTERIES Warning/Protection Alarms Warning Alarms Cell under voltage warning Cell over voltage warning Battery under voltage warning Battery over voltage warning Charge over current warning Discharge over current warning Low ambient temperature warning High ambient temperature warning Mos low temperature warning...
Need help?
Do you have a question about the SNLXMTSOC and is the answer not in the manual?
Questions and answers