Advertisement
Quick Links
80200 UNIVERSAL STAND
UNPACKING & INVENTORY
NO
DESCRIPTION
A
Upper Leg
B
Lower Leg
C
Upper Brace ( Short )
D
Upper Brace ( Long )
E
Lower Brace ( Short )
F
Lower Brace ( Long )
G
Rubber Foot
QTY
4
NO
4
H
2
I
2
J
2
K
2
L
4
HARDWARE PACK
DESCRIPTION
Flat Washer, Ø 6.3 Ø 18 1.5
Hex Nut, M6 P1.0
Hex. Head Bolt, M6 P1.0 70L
Carriage Bolt, M8 1.25-16
Hex Flanged Nut, M8 1.25
QTY
8
4
4
32
32
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Cutech 80200
Summary of Contents for Cutech 80200
- Page 1 80200 UNIVERSAL STAND UNPACKING & INVENTORY DESCRIPTION HARDWARE PACK Upper Leg DESCRIPTION Lower Leg Flat Washer, Ø 6.3 Ø 18 1.5 Upper Brace ( Short ) Hex Nut, M6 P1.0 Upper Brace ( Long ) Hex. Head Bolt, M6 P1.0 70L Lower Brace ( Short ) Carriage Bolt, M8 ...
- Page 2 ASSEEMBLY Step 1: Place upper brace (long) on the upper leg piece. NOTE: Upper brace (long) has five holes on each end. These holes should be on top when leg stand is completely assembled Step 2: Align holes on the upper brace with the holes on the leg piece. Insert two carriage bolts and hand tighten using hex nuts.
- Page 3 Mounting A Machine on The Stand (Applicable for Certain Models) TO AVOID serious injury, death, or damage to the machine, DO NOT mount any machine on the stand until the stand is completely assembled. DO NOT run the machine until it is mounted on the stand securely. Step 1: Mount your machine on the stand.
- Page 4 Mounting A Machine with a board The board (not included) may be required to be attached your machine to the stand. Prepare a piece of 5/8" to 3/4" thick plywood to the top dimensions of the stand (23"x 14") or a bit larger. ⚫...
Need help?
Do you have a question about the 80200 and is the answer not in the manual?
Questions and answers