Evolveo DoorPhone W7 RELAY User Manual

DoorPhone W7 RELAY - User's manual
EN
V1 / 9. 10. 2024
SAFETY NOTICE
This device is electrical in nature and contains a 250V/10A relay, powered by a 12V/0.1A power supply. When
handling the equipment, always observe the principles of safe working with electrical equipment. Improper
installation or handling can lead to electric shock, damage to the equipment or fire. Ensure that all wires and
connections are properly insulated. Always disconnect the power before starting installation or maintenance of the
equipment.
Prohibited uses: Do not use this equipment in the following cases, as these uses are in violation of the warranty
and may result in irreversible damage to the equipment:
Connecting to the wrong power supply - Only power the device from the correct 12V/0.1A power supply. Using a
different voltage or power supply with a higher current load may cause damage to the device or cause it to
malfunction.
Overload relay - The relay in this device is designed for current up to 10A and voltage up to 250V. Do not connect
the device to a load that exceeds these values or overheating, relay damage or short circuit may occur.
Use in extreme conditions - The device should not be exposed to excessive temperatures, humidity or dust.
Installation in an environment outside of the recommended operating conditions (dry indoors, normal
temperature) may lead to failure.
Manipulation without disconnecting power - Any tampering with the device or changes to its configuration must be
performed only when the power is turned off. Handling while the power is on is dangerous and can result in electric
shock or damage to the equipment.
Unauthorized modification or repair - Any unauthorized modification or repair of the equipment will result in
immediate voiding of the warranty. A qualified technician must be called in for any modification or repair of the
equipment.
Failure to follow these guidelines can not only cause the equipment to malfunction, but also lead to loss of
warranty and increased risk of dangerous situations.
CONNECTIONS
INSTRUCTIONS FOR USING THE UNLOCKING MODULE
Warning: The unlocking module is already paired with the device from the factory, no need to pair again. If the
module is not paired, contact after-sales service and follow the instructions below.
Connect the lock to the unlocking module according to the diagram and then connect the power supply.
Hold the pairing button on the unlock module for about 5 seconds until the red light starts flashing.
On the display inside in monitoring mode, press the unlock button to open the lock, the lock will unlock and the
unlocking module will make a "di" sound to indicate successful pairing.
After successful pairing, you can set the unlock time, with the default unlock time being 1 second. To set the unlock
time, do the following: