esotec Super Spot pro Duo Color 102546 Operating Instructions

Operating Instructions
Solar Lamp Super Spot pro Duo Color
Customer support:
If you have problems or questions regarding this product, simply contact us!
esotec GmbH, Industriegebiet Weberschlag 9, D-92729 Weiherhammer
Internet: www.esotec.de
By phone: +49 9605-92206-0
By e-mail for ordering spare parts: ersatzteil@esotec.de
By e-mail for questions about the product: technik@esotec.de
Battery take-back
- Batteries must not be discarded into domestic waste.
- The consumer is legally required to return batteries
after use, e.g. to public collecting centers or to battery
distributors.
- Contaminant-containing batteries are labeled with the
sign "crossed-out trashcan" and one of the chemical
symbols. Used batteries should be disposed environ-
mentally friendly and should not be discarded into
domestic waste. Your dealer is legally required to take
back old batteries.
Rechargeable battery notes
- Rechargeable batteries should not be played with by children. Never
leave rechargeable batteries lying around; they could be swallowed
by children or pets.
- Rechargeable batteries must never be short-circuited, disassembled
or thrown into fire. This leads to a danger of explosion!
- Leaking or damaged rechargeable batteries can cause chemical
burns when they come into contact with skin. For this reason, please
make use of suitable protective gloves.
- Rechargeable batteries should only be replaced by structurally iden-
tical rechargeable batteries from the same manufacturer. Normal
batteries must not be used since these are not rechargeable.
- Make sure the rechargeable batteries are inserted with the correct
polarity.
- For long periods of time of non-use (for example, storage), remove
the inserted rechargeable batteries to avoid damages via the leaking
rechargeable batteries.
Disposal:
Dear customer,
please cooperate in avoiding waste. When you intend to
dispose of the product in future, please consider that it
contains valuable raw materials suited for recycling.
Therefore, do not dispose it of with domestic waste but
bring it to a collection point for the recycling of waste
electrical and electronic equipment.
Thank you very much for your cooperation!
1. Introduction
Dear customer, we thank you for purchasing the Solar Globelight.
With this Solar Light you have purchased a product that complies with the
latest and most up-to-date technology.
This product complies with the European and National
Standards. The relevant certificates of conformity are
deposited with the manufacturer.
To preserve this standard and in order to maintain safety
you must adhere to the use instructions!
2. Security Instructions
In the event of any problems arising or damage occur-
!
ring from not following these instructions, the warranty
is deemed cancelled. The manufacturer will not be held
responsible for any claims or damages arising from the
misuse of this product.
- For safety reasons and in order to maintain standards (CE) you are pro-
hibited from altering or changing any component in the product.
- Please follow the instructions very carefully.
- For commercial applications due care and attention must be paid to the
Health and Safety Standards in your jurisdiction.
3. Function and intended Use
GB
The solar light is designed for outdoor use (protection class IP54). The
built-in battery is charged by the solar cells when sufficient sunlight shines
on it.
The solar light switches on automatically at dusk and off again at dawn. The
integrated LEDs guarantee high luminosity with low power consumption.
Due to the principle, the luminous period is reduced when there is little
sunlight on the solar module (e.g. during rainy weather or in the winter
months).
As a special feature, the light colour of the LEDs can be switched between
"warm white" and "cold white". The luminous intensity is automatically
regulated between 30 and 100 lm depending on the charge level of the
battery. This ensures an extremely long lighting duration.
The safety instructions and all other information in these operating
instructions must be followed. Read the entire operating instructions
carefully before installation and commissioning.
Note: During longer periods with insufficient insolation, the accumulator is
LiIon
charged insufficiently via the sunlight. However, that does not mean that
the solar lamp is defective. Please wait for the next sunny days and the
light will work accordingly.
The rechargeable battery has to be exchanged every 2-3 years on
average!
4. Putting into Operation
1. Please carefully take all parts out of the package.
2. Mount the solar module onto the spot by means of the screw and nut.
The module can be mounted in two different variants depending on the
place of installation. Thus, you are able to optimally adjust the module
to the sun depending on the local circumstances (illustration 1).
1.
3. Now mount the aluminum ground spike onto the spot by means of the
assembly material (illustration 2).
4. Move the switch at the bottom side of the solar module into the position
„ON" (illustration 3).
5. The pressure switch on the other side of the solar module is used to
select between the light colors cold white or warm white (illustration 4).
6. Now firmly insert the spot with the ground spike into the ground. Adjust
the beam according to the local circumstances and tighten the screw
on the ground spike.
7. Now, adjust the solar module free from shadows facing the sun and
also tighten the screw on the solar module.
The spot is now ready for use!
2.
Note: The duration of illumination strongly depends on the intensity
and duration of the solar radiation during the day. During the winter
months please generally expect a shorter light ON time. If the lamp
should not shine on the first evening, please wait for a sunny day.
3. 4.