Hearst Communications GOOD HOUSEKEEPING 92512 Instructions

5" Personal Retro USB Fan 5" Personal Retro USB Fan
READ AND SAVE THESE INSTRUCTIONS!
WARNING:
To reduce the risk of fire or electric shock, do
not use this fan with any solid-state speed control device.
RULES FOR SAFE OPERATION:
• Use this fan only for purposes described in this manual.
• This fan is intended for household use only and not for
outdoor, commercial and industrial use.
• This fan is not intended for use in kitchens.
• To protect against electric shock, do not immerse unit or
cord in water or spray with liquids.
• Close supervision is necessary when any appliance is used
by or near children.
• Do not insert fingers or any objects through the grill guard
when fan is in operation.
• Do not operate this unit without fan guards properly locked.
• Avoid contact with moving parts.
• Do not operate in the presence of explosive and/or
flammable fumes.
• Do not place fan or any parts near an open flame, cooking
or other heating appliance.
• Do not hang or mount fan on a wall or ceiling.
• Do not let the cord hang over the edge of a table, counter
or come into contact with hot surfaces.
• Do not run cord under carpeting. Do not cover cord with
throw rugs, runners, or similar coverings. Do not route
cord under furniture or appliances. Arrange cord away
from traffic area and where it will not be tripped over.
• Do not operate fan after a malfunction or has been
dropped/damaged in any manner.
• Always use on a dry, level surface.
62803-01
Operating Instructions:
1. Set the Fan Base on a dry, level surface.
2. USING USB DC SUPPLY: Make sure the On/Off Switch
Model
92512 92517
92513 92518
92514 92519
92515 92520
92516
3. Now switch the fan to the "on" position by sliding the
4. To make the fan oscillate, press the Oscillation Knob
Fan Parts:
A. Fan Grill
B. Switch
C. USB Cable
D. Oscillation Knob
E. Type C Port
Care and Maintenance Instructions:
WARNING:
• Always unplug from electrical supply source before
cleaning.
• Do not allow water to drip on or into the fan motor
housing.
• Be sure to use a soft cloth moistened with mild soap
solution. Do not use harmful cleaners.
• After servicing, all safety devices (including grills and
blades) must be reinstalled or remounted as previously
installed.
20230628
located at the side of the fan is at the right (Off)
position. Insert the USB cord to the type C port at the
back of the fan. Plug the USB cord into any standard
USB port, such as the USB output jack from a PC.
Warning:
Only use DC 5V power.
Switch to the left.
once. To stop oscillating, press the Oscillation Knob
again. The Oscillation Knob is located on the top of
the fan housing.
A
B
D
E
C