Custom Audio Electronics RP312 Short Manual

Technical speciication

IP-67 certiied

1.22M(4ft) drop-resistance
 Mediatek MTK 6765 64 BIT/8 Cortex A-53 2.3 GHz

Memory
Storage
Integrated microphone
Audio
Integrated speaker


Rear: 8.0 megapixel AF camera with LED
Accelerometer (G-sensor)
Sensors 3-axis digital gyroscope
E-Compass/Proximity Sensor
Light Sensor Ambient light sensor
 Integrated IEEE 802.11 a/b/g/n/ac
Bluetooth Integrated Bluetooth 5.0 with HID input

Navigation GPS, Glonass
Barcode scanner 1D/2D barcode reader with physical trigger keys

10-point capacitive touch screen
Type
AGC Dragontrail glass

Size / type
Resolution

Power system Lithium-ion rechargeable battery
Battery type
Battery capacity
Battery life Up to 8 hours
Adapter input AC 100~240 V, from 50 to 60 Hz
Adapter output
ENVIRONMENTAL CONDITIONS
Operating temperature from 5°C to 45°C
Storage temperature from -30°C to 70°C
Comes with Google™ app and Google Chrome™
Android is a trademark of Google LLC.

BATTERY
 The rechargeable battery can be used to power your device. Charge the battery
when the power level is low. It is recommended that you use up the entire battery
charge before recharging, to ensure longer battery life.
 Do not connect the charger to any power source if it is not in good condition.
3. Never connect the charger to the battery for more than one week because over
charging shortens battery life.
Android™ 12
 Temperature afects the battery charge limits, so it may be necessary to cool or to
warm the battery before charging. Recharging will not be successful if the battery
4 GB
temperature is above 55°C or below -20°C.
64 GB 5. To avoid short circuits use the battery only for the purpose for which it was originally
designed. A short circuit will occur if the battery cathode and anode are connected
by a conductor.
 Never use the battery if it is damaged.
 Battery life will be reduced if the battery is in an extremely hot or extremely cold en
vironment. The device may not function properly, even if the battery is fully charged,
if the battery is exposed to extremely hot or extremely cold environmental conditions.
8. Do not throw the battery into a ire. Dispose of used batteries responsibly.
Front: N/A
 Used batteries should be taken to battery recycling services and disposed of ac
cording to local regulations.
DEVICE
 Keep your device and all accessories out of the reach of children.
 Keep your device dry as liquids can corrode the metal circuits. Keep your phone
away from high temperatures because high temperatures can reduce the life of
electronic components, melt plastics and damage the battery.
3. Do not attempt to open the device case or disassemble the phone.
 Non-professional disassembly will potentially damage the phone. Do not use deter
gents containing strong acids or strong alkaline to clean your phone.
Support
5. Always use the original accessories, otherwise the warranty will be void.

 When using your device, always comply with the safety rules to protect users and
the environment.

 Except in case of an emergency, do not use your device while driving unless hands-
free devices are connected to ensure safety and freedom of movement.
 Make sure you are completely focused on driving. Park your vehicle in a safe place
before using your device. Comply with all applicable regulations. Some electronic
devices may be afected by radio waves transmitted by your device if suicient
protection is not provided.
5" IPS LCD
3. It is recommended that you use your device only in vehicles with an external antenna.
 Always employ qualiied technicians to install your device in your vehicle.
1280 × 720
5. Flight safety
 Switch of your device before boarding, as devices interfere with the operation of
aircraft and the entire mobile network. It is illegal to use devices on aircraft and
violation of these safety regulations will result in a denial of customer service.
ENVIRONMENTAL SAFETY
 Remember to always comply with all current applicable rules and policies.
Replaceable
 Always remember to switch of your device when its use is prohibited or maycause
interference or hazards.
4000 mAh
3. Use of any wireless transmission equipment, including your device, may interfere
 with an inadequately protected medical device. Consult your physician or medical
device manufacturer if you have any questions about this. Your device may interfere
with hearing aids, pacemakers and other electronic medical devices. Follow the
recommendations of your doctor or the manufacturer.
5. Users are recommended to switch of their devices at any places where an explo
5V, 2A
sion may occur, e.g. gas stations and chemical plants. Comply with any restrictions
on the use of wireless devices.


EU-wide legislation, as implemented in each Member State, requires that
waste electrical and electronic products carrying the mark (left) must be
disposed of separately from normal household waste.

This includes monitors and electrical accessories, such as signal cables or
power cords. When you need to dispose of your display products, please follow
the guidance of your local authority, or ask the shop where you purchased
the product, or if applicable, follow any agreements made between yourself.
The mark on electrical and electronic products only applies to the current
European Union Member States.

This device was tested for typical body-worn operations. To comply with RF exposure
requirements, a minimum separation distance of 0mm must be maintained between the
user's body and the handset, including the antenna. Third-party belt-clips, holsters, and
similar accessories used by this device should not contain any metallic components. Body-
worn accessories that do not meet these requirements may not comply with RF exposure
requirements and should be avoided. Use only the supplied or an approved antenna.
This device in compliance with the essential requirements and other relevant provisions
of Directive 2014/53/EU. All essential radio test suites have been carried out.
 Use careful with the earphone maybe possible excessive sound pressure from
earphones and headphones can cause hearing loss.
 CAUTION : RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT
TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
3. The product shall only be connected to a USB interface of version USB 2.0.
 Adapter shall be installed near the equipment and shall be easily accessible.
5. The plug considered as disconnect device of adapter.
 The device complies with RF speciications when the device used at0mm form
your body.
This product can be used across EU member states.
FCC Caution:
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
This Product meets the government's requirements for exposure to radio waves.
The guidelines are based on standards that were developed by independent
scientific organizations through periodic and thorough evaluation of scientific
studies. The standards include a substantial safety margin designed to assure the
safety of all persons regardless of age or health.
FCC RF Exposure Information and Statement the SAR limit of USA (FCC) is1.6 W/
kg averaged over one gram of this Device RP312 (FCC ID: OAH-5221120) has
been tested against this SAR limit. SAR information on this can be viewed on-line at
http://www.fcc.gov/oet/ea/fccid/. Please use the device FCC ID number for search.
This device was tested for typical operations 10mm from the body. To maintain
compliance with FCC RF exposure requirements, 10mm separation distance
should. maintained to the user's bodies
NOTE:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
The WLAN function for this device is restricted to indoor use only when operating in
the 5150 to 5250 MHz frequency range
EU Market

RP312