Summary of Contents for Frigicoll MH-KIT
- Page 1 INSTALLATION & OWNER’S MANUAL MH-KIT IMPORTANT NOTE: Thank you very much for purchasing our product, Before using your unit , please read this manual carefully and keep it for future reference.
-
Page 2: Table Of Contents
CONTENTS SAFETY PRECAUTIONS ---------------------------------------------------------------------------- 01 GENERAL INTRODUCTION ----------------------------------------------------------------------- 02 y 2.1 Function description ------------------------------------------------------------------------------------ 02 INSTALLATION GUIDELINE --------------------------------------------------------------------- 02 y 3.1 Accessories ------------------------------------------------------------------------------------------------ 02 y 3.2 Installation ------------------------------------------------------------------------------------------------- 02 CONTROL BOARD -------------------------------------------------------------------------------------- 03 WIRING CONNECTION ------------------------------------------------------------------------------- 04 y 5.1 Power supply ---------------------------------------------------------------------------------------------- 04 y 5.2 Communication connection --------------------------------------------------------------------------- 04... -
Page 3: Safety Precautions
1 SAFETY PRECAUTIONS The precautions listed here are divided into the following types.They are quite important, so be sure to follow them carefully. Read these instructions carefully before installation. Keep this manual in a handy for future preference. Meanings of DANGER, WARNING, CAUTION and NOTE symbols. DANGER Indicates an imminently hazardous situation which if not avoided, will result in serious injury. -
Page 4: General Introduction
2 GENERAL INTRODUCTION MH-kit is used to shorten the field connection cable length between hydraulic module PCB and TBH, external electric heater, AHS, SV1, SV2, SV3, PUMP_O, PUMP_D, PUMP_C, PUMP_S, P_X, making the installation more flexible. Hydraulic module board PCB... -
Page 5: Control Board
330mm 3.2.2 MH-kit installation and fixed way Drill four holes where you want to install the MH-kit, with the positions of the holes shown below. Secure the MH-kit using screws.The MH-kit must be installed vertically on the wall. (Wall or obstacle) (Wall or obstacle) ≥... -
Page 6: Wiring Connection
NOTE If the Tbt and T5 terminals need to be connected, you can unplug the connecting wire from the corresponding position on the Hydraulic module board and plug it into the MH-kit PCB board port. 5 WIRING CONNECTION 5.1 Power supply 5.1.1 MH-KIT Power Supply Wiring... - Page 7 The DIP switch S4-3 of hydraulic module PCB of M thermal Arctic Series must set to ON. If the HMI displays "EL" fault code means communicate problem between the MH-KIT with the hydraulic module board. 5.2.2 Connection with M-Thermal Arctic HT Series Connect 3 shielded wires(3*0.75 mm...
- Page 8 NOTE:...
Need help?
Do you have a question about the MH-KIT and is the answer not in the manual?
Questions and answers