Fingertech Robotics COLOSSUS Quick Start Manual

COLOSSUS
CONTENTS
1x Wood Panel Set
1x Circuit Board
2x Drive Motors
1x Weapon Motor
1x Steel Pipe
1
Weapon Motor
s
5mm Wood Screw
4
Once this step is completed,
you can now stretch the included
M3 Locking Nuts
elastic band around the two pulleys
as shown below.
M3 x 40mm Screws
7
Unplug the Battery Input Cable
from the Circuit Board. Feed its
small white connector through
the Steel Pipe. Identify the Drive
Motor with the longest wire and
10
5mm Flanged Wood Screws
Build Time:
45 - 60 Minutes
1x Bearing
1x Pulley
12x Rubber Pads
1x Battery Pack
1x Elastic Band
2
10mm Wood Screws
5
8
Circuit Board
feed this wire through
the same way.
11
4x M2 Self Locking Nuts
3x M3 Self Locking Nuts
2x 5mm Flanged Wood Screws
2x 5mm Flat Cap Screws
2x 5mm Wood Screws
4x 10mm Wood Screws
4x M2 x 20mm Screws
3x M3 x 40mm Screws
M2 x 20mm Screws
M2 Locking Nuts
Drive Motors
Plug the Battery Input Cable back into the Circuit
Board. Plug the Drive Motors & Weapon
Motor into their labelled connectors on
the Circuit Board as well.
Rubber Pads
3
10mm Wood Screws
Pulley
Bearing
Sand Flats onto outer two rings
6
5mm Flat Cap Screws
Circuit Board
Battery Input
W - Weapon Motor
R - Right Drive Motor
L - Left Drive Motor
9
slide it into the available space.
You may have to move some wires
Complete
Steel Pipe
Plug the Battery into the
Battery Input Cable and
out of the way to make room.
FT0519-270723