xsto CT310 Operation Manual

Powered stair climber

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

Download this manual

xstoclimbers.com

OPERATION MANUAL

POWERED STAIR CLIMBER

CT310

Table of Contents

Need help?

Do you have a question about the CT310 and is the answer not in the manual?

Questions and answers

Summary of Contents for xsto CT310

Page 1 OPERATION MANUAL POWERED STAIR CLIMBER CT310...
Page 2: Table Of Contents
2.6 Standard Supply Accessories ..............6 2.7 Installation instructions ................7 3 Operation ....................7 3.1 Check Before Using CT310 ..............8 3.2 Usage of hand-held Controller ............10 3.3 Adjustment of Handle and Strap Holder ...........12 3.4 Operate on Flat Ground ............... 12 3.5 Adjust loading board ................
Page 3: Symbols And Safety Instructions
Do not reach under the load plate or touch the rotating part and  track. Do not use the CT310 in rainy, wet, snowy or icy condition and  sideslip or other potential dangers may be caused.
Page 4 Do not use CT310 if the crawler track is broken.  Do not use CT310 on road that is slippery or with barrier.  Do not use the CT310 on the escalators or moving belts.  Turn off the CT310 immediately if the drive part is stuck.
Page 5: Description
4: hand-held controller 5: Telescopic elbow rail 6: Handrail support 7: battery base base 2.2 Technical data This user manual is for CT310 series ONLY. 2.3 Application fields This series of products are new type of stair climber that can...
Page 6: Technical Parameters
2.4 Technical Parameters Stair Climber CT310 Technical Parameters Model CT310 Height: MIN 1132 mm, MAX 1375 mm...
Page 7: Dimension
IP54 Lifespan 3years/50000steps Note ： CT310 parameters are suitable for ambient temperature 25℃. In a low-temperature environment, the load and endurance will be reduced. If the low-speed mode is started, the endurance will be reduced accordingly. This product is recommended to be used within 1000 meters above sea level.
Page 8: Standard Supply Accessories
2.6 Standard Supply Accessories Main Body Battery Pack Charger, 24V (for Lithium battery Only) Safety Strap Strap Holder...
Page 9: Installation Instructions
2.7 Installation instructions Open steel back support of the CT310 to vertical Angle. Secure CT310 back support panel with plum knob. 3 Operation Note — Please put the machine in the environment without freezing(above 0 ℃) before initial operation! Warning——Only trained person can operate CT310.
Page 10: Check Before Using Ct310
3.1 Check Before Using CT310 Warning Stop operation when the following issues occur and contact manufacturer or local dealer for CT310 repair. (1) The battery has been fully charged, but the handheld...
Page 11 (6) CT310 makes abnormal sound during functioning. (7) Switch on the battery and the universal wheel touches the ground, press the "A " for the first time to make CT310 in the automatic adjustment mode of the loading board, however the loading board cannot be adjusted to 9 ~ 11°...
Page 12: Usage Of Hand-Held Controller
Mode button automatic adjusting on /off Joystick Joystick: Control the CT310 to move forwards and backwards or to flip the loading board. Loudspeaker: Press loud, press again to stop loud, warning function. Speed down/up: There are five speed level, and the speed gradually increases from level 1 to 5.
Page 13 3.2.2 Track running mode and loading board manual adjustment mode Press this button to Displays that the mode switch current mode is different mode,it will track mode. switch from left right, Displays that the loading triangle arrow points board automatic adjusting to the current mode.
Page 14: Adjustment Of Handle And Strap Holder
And then the operator can push the handle to move CT310 forward on flat ground. This way can be applied on flat ground ONLY. Warning: When the slope of the ground is bigger than 5 °...
Page 15: Adjust Loading Board
3.4.2 Track walks on flat ground The CT310 can walk on flat ground with crawler tracks. Switch to the loading board manual operation mode, raise the loading board to an angle till the crawler tracks touch the ground, and then the operator can move the machine by controlling the joystick.
Page 16 When CT310 is under automatic adjustment mode, if the horizontal tilt angle of the loading board is adjusted to less than 7°or more than 30 ° , CT310 will automatically adjust the angle of the loading board to raise loading board to 7° or lower to 30°.
Page 17: Go Upstairs
After the CT310 (lithium battery switch) turns on, it switches to the automatic adjustment mode for the first time with the horizontal angle less than 7°. At this time, The CT310 will adjust the horizontal angle of loading board to 10°.
Page 18 3.6.2 Initial position Make sure the goods are fixed securely, move CT310 to the edge of the stairs and make sure the two tracks lean against the edge of the first stair. Turn on loading board...
Page 19 Then use the joystick to move up further. Warning: There is potential risk when CT310 moves up to the highest stair on every floor. CT310 may roll over forward or...
Page 20: Downstairs
3.7 Downstairs 3.7.1 Start the CT310 stair climber Insert the 24V battery pack and turn on the battery switch. Note: Before turning on the...
Page 21 Warning-There is potential risk when CT310 moves on the highest stair. CT310 may roll over forward or backward. Make sure there is nobody and no goods beneath the stair. When a rollover is inevitable, loosen the armrest and dodge in time. Personnel shall avoid from the side.
Page 22 When CT310 gets off the edge of the platform totally and goes down stably, cancel automatic mode. If the base of CT310 is unstable when going downstairs, adjust to rotating mode by hand-held controller. Adjust manually loading board tilt angle...
Page 23: Turning Operation On Flat Ground Or Platform
NOTE: When the loading board angle is automatically adjusted, the speed of going up and down the stairs will be automatically reduced to ensure safe going up and down. When the automatic balance adjustment is completed, the original speed will be restored. Under the automatic adjustment mode of the loading board, in the initial stage of going upstairs, only the joystick needs to be controlled, and no other operation is needed.
Page 24: Maintenance
When parking, ensure that the CT310 is stored on the horizontal ground stably without shaking. If the storage place is likely to cause CT310 slide, raise the loading board to an angle so that tracks can land, preventing accidents or losses caused by machine sliding.
Page 25 Note: Use a dedicated 24V lithium battery charger, the output voltage is: DC 29.4V. NOTE: Don’t start CT310 while the battery is in charging. Battery instructions and precautions (1) Storage When the battery pack to be long-term stored, charge the battery pack to about 50% capacity, store in dry and ventilated place, charge for every 3 months.
Page 26 The charging temperature range is 0-40℃. If the range is exceeded, the battery performance will be reduced and the battery life will be reduced. (2) Transportation The battery pack and charger should be packaged for transport, prevent excessive vibration, shock or extrusion in transport process and prevent the sun and rain.
Page 27 Check the Charger output charger output plug Battery pack plug loose: and battery plug is cannot be charged. Battery pack is firm or not; fully charged. Battery pack can be used normally. f) Warranty period of the battery Warranty period of this product is 12 months from delivery date. Cycles: 500 times, capacity≥80%.
Page 28: Exchange The Fuse
*If the battery pack gives off odor, gets heat, deformation, discoloration or appears any abnormal phenomenon, stop using it; please remove the battery from electrical appliances and stop using it, when the battery is being used or charged! *Forbid to use battery pack in a very hot environment, such as under direct sunlight or in car on hot day.
Page 29: Recycling
4.4 Precautions for care and use * Store CT310 in an environment above 0 ° C for at least one hour before the initial operation. * Do not exceed the rated weight.
Page 30: Faq
Rated load of less then 70%,the than 2 minutes. maximum continuous running time is less than 4 minutes. 4.5 FAQ Q1: Where can the CT310 be used? A1: CT310 is a multi-functional intelligent handling equipment, it is suitable for use buildings, factories,...
Page 31 Q2: Can the CT310 be used on rainy days? A2: The IP rating of CT310 is IP54, which has the ability of dust and splash proof, but it cannot be used in rainy days and water. Q3: Can the CT310 handle all heavy loads? A3: The CT310 has a rated load of 310KG.
Page 32: Packaging Box And Shipping Instructions
The carton part uses a high-strength carton that can bear a weight of 500KG. The CT310 can only be stored in a way that the carton is stacked on the pallet. The CT310 box can bear two layers of stacking.
Page 33: Basic Size Of Packaging Box
5.2 Basic size of packaging box Unit: mm 6 Warranty and responsibility 6.1 Warranty The warranty period of the product is 12 months. Any damage caused by the following reasons is not covered by the warranty: *Damage caused by overload work; *Damage caused by incorrect operation *Damage caused by violence *Natural wear of casters, safety strap, etc.
Page 34: Responsibility
*Inappropriate equipment operation *Repair, dismantling or other operations of the equipment without authorization *Operation manual is not followed *For the installation of special accessories for CT310 *Deliberately dismantle the configuration of CT310 *Operation under overload conditions *Operation under low battery capacity If the contents of this specification are changed because ...
Page 36 +86-760-28207258 info@xsto.net Floor 1, Building C, 555 Plant. Ma’an Cun Rd, Cuiheng New District, Zhongshan City, Guangdong, China...