Advertisement
Quick Links
Model # PGC-RE
Tools Required for Assembly
Level
Tape measure
Auger / Post hole digger / Shovel
High speed 3/8" electric drill w/clutch
T45 TORX tool (supplied by manufacturer)
Recommended Crew
One Person
ELEPHANT RIDER
PLAY COMPONENT
Please Note
Use of any other driver may result in damage to tool
and/or hardware.
Installation Time
One Hour
Concrete Required
3.53 Cubic Feet
Pre-Installation Check:
Compare all items received to the packing list. Notify your local sales
representative immediately if any parts are missing or damaged.
Before beginning installation, make sure that you have read and
understand the Installation Introduction manual that was supplied to you.
If you did not receive a copy, or if you have a question regarding
anything covered in this manual, contact your local sales representative.
www.belson.com
627 Amersale Drive
Naperville, IL 60563
Phone: (800) 323-5664
Fax: (630) 897-0573
sales@belson.com
Instructions Sheet
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for Belson Outdoors PGC-RE
- Page 1 627 Amersale Drive Naperville, IL 60563 Phone: (800) 323-5664 Fax: (630) 897-0573 sales@belson.com Model # PGC-RE Instructions Sheet ELEPHANT RIDER PLAY COMPONENT Tools Required for Assembly Please Note Level Use of any other driver may result in damage to tool and/or hardware.
- Page 2 Step 1: Refer to PLAN VIEW and FOOTING LAYOUT to locate position of elephant rider. Step 2: Excavate footing as shown in FOOTING LAYOUT and FOOTING ELEVATION. Place a 2” spacer in bottom of hole. Step 3: Select torsion axle with ground anchor, elephant rider, four 3/8”x1” security TORX bolts and four 3/8”x1-1/4” washers. Attach elephant rider to torsion assembly by inserting bolt through washer, torsion axle and gently tighten into rider.
- Page 3 ELEVATION VIEW 23-5/8" Surfacing 12" Grade 24" PLEASE NOTE: Seat must be 14" to 28" above the finished surfacing. FOOTING ELEVATION Impact Attenuating Surfacing (refer to CPSC fo depth from Sub-Grade) Surface Warning Label Sub-Grade 4" 24" Block (not provided) 18"...
Need help?
Do you have a question about the PGC-RE and is the answer not in the manual?
Questions and answers