Advertisement
Quick Links
1. Product Features
This gateway is a monitoring device that collects status of lubricators using Bluetooth.
LK-B100 is a device that gathers the data of lubricators which transmitted to the BLE and transfer to the
central management device using Ethernet.
Current status can be determined when the LED indicator blinks.
With a check button, the cause of the defect can be found if the error occurs.
2. Product Specifications
Item
Ethernet
Bluetooth version
Bluetooth Frequency
Indicator LED
ANT
KEY
Input voltage
Input power connector
Ethernet connector
BLE Tx power class
BLE Rx sensitivity
BLE data rate
Operating current
Operating temperature
Operating humidity
Storage humidity
certification
Size
Weight
LK-B100/LK-B101 User Manual
802.11 (10/100M) Network (LAN)
BLE 4.2
2.402~2.480MHz
Red, Green
External 2.4G ANT
On/off button, check button
4.0~6.0V
This equipment must be supplied from a power source of less than 15W.
DC jack
RJ45 standard
~10dBm
~93dBm
~1Mbps
~200mA
℃
-10~60
20~90%
10~90%
KC, CE, FCC
133mm X 100mm, T : 40mm
205g
Spec
Rev.00
Advertisement
Summary of Contents for Pulsarlube LINK LK-B100
- Page 1 Rev.00 LK-B100/LK-B101 User Manual 1. Product Features This gateway is a monitoring device that collects status of lubricators using Bluetooth. LK-B100 is a device that gathers the data of lubricators which transmitted to the BLE and transfer to the central management device using Ethernet. Current status can be determined when the LED indicator blinks.
- Page 2 Rev.00 3. Product Image 4. Installation Guidelines How to enter setup mode Press power button to turn the device off. ① Press check button and power button to enter setup mode. ② Check the setup mode Red/Green LED blinks for 2 seconds by 200ms. ③...
- Page 3 (5) Do not attempt to connect unsuitable outputs or inputs. 6. Certifications 7. Manufacturer 34-12, Bangchon-ro 955beon-gil, Tanhyeon-myeon, Paju-si, Gyeonggi-do, Republic of Korea HOMEPAGE www.pulsarlube.co.kr E-MAIL klt_sales@pulsarlube.com FCC Instructions FCC Compliance Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
- Page 4 Rev.00 interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to correct the interference by one of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. •...
Need help?
Do you have a question about the LINK LK-B100 and is the answer not in the manual?
Questions and answers