Download Print this page

Prusa Research RC1 How To Assemble

Face shield

Advertisement

Quick Links

Personal protective equipment for work in a harsh environment
1
Separate the headbands, clean all four
pins. Remove the protective films from
both sides of the visor and insert the
middle part of the visor first, then flex the
headband and snap-in both ends.
3
Attach the rubber band to both ends
of the headband, adjust the length as
necessary.
DISINFECTION (BEING VERIFIED): IPA (MIN 75%), ETHANOL (MIN 78%) AND VIRUCIDE SOLUTIONS,
DISINFECT AT LEAST FOR 5 MINUTES, OTHER PROCEDURES AT: WWW.PRUSA3D.COM/DISINFECTION
DETAILED ASSEMBLY
INSTRUCTIONS AND VIDEO
VERSION RC3
2
Brace the shield against your body or
solid surface and snap in the bottom
part (chin).
4
We're done! Disinfect the shield before
use. Suggestions for improvements
send to: covid@prusa3d.com

Advertisement

loading
Need help?

Need help?

Do you have a question about the RC1 and is the answer not in the manual?

Questions and answers

Summary of Contents for Prusa Research RC1

  • Page 1 Personal protective equipment for work in a harsh environment Separate the headbands, clean all four Brace the shield against your body or pins. Remove the protective films from solid surface and snap in the bottom both sides of the visor and insert the part (chin).
  • Page 2 We appreciate all your feedback, email: covid@prusa3d.com Printing of plastic parts (headband + bottom brace): When printing, the plastic heats up to a high temperature (over 200 °C). After printing, the operator wears a face mask and a new pair of gloves and puts the printed parts into a sealable zipper bag.