Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for BenQ DentCare BQP-D15
- Page 1 BQP-D15 3D Printer Installation Guide...
-
Page 2: Table Of Contents
Content Unpacking & Inspecting the Printer Inspection Unpack Location Package Contents Product Overview Power & Network connection Connecting To The Power Adapter And Cable Power IP Address Motor & Projector Operations Test Print Printing Requirements Printing Post Processing Installation Checklist... -
Page 3: Unpacking & Inspecting The Printer
Unpacking & Inspecting the Printer Inspection 1) Check if box have been opened 2) Check if any damage occurred on the box In this scenario, the printer package was not handled properly during the shipment procedure. ・ Photograph the damage ・... -
Page 4: Unpack
If the printer is damaged — ・ Photograph the damage ・ Contact the BenQ AB DentCare distributor office with details of the damage. If the damage to the printer might prevent the printer from working safely or efficiently, stop and wait for instructions from the regional BenQ AB DentCare office. -
Page 5: Location
Location Ensure your BQP-D15 is placed on a flat table top with access to mains electricity. Avoid sunlight direct as this will degrade material left in the machine. (1) Required at least 20cm space around the (2) When open the cover, make sure there’s printer. -
Page 6: Product Overview
Product Overview ・ Take out the resin tank module and check if the film isn’t damaged. ・ Check the protective glass screen if it has been damaged while transportation. -
Page 7: Power & Network Connection
Power & Network connection Connecting To The Power Adapter And Cable (1) Connect the power cord and adapter to BQP-D15, and then plug it into an electrical outlet (2) Connect your printer with laptop • Basic : Connect printer and laptop by RJ-45 cable (Graph1.) [Initiating time 1 minute] • LAN : Connect both printer and laptop to local area network [Initiating time a few seconds] • IP sharer : Connect both printer and laptop to IP sharer [Initiating time a few seconds]... -
Page 8: Motor & Projector Operations
Motor & Projector Operations • For testing internal machine components, u se of touch panel should be done. • This setting can also be used using the computer by inserting IP address in your computer browser & adding :8080 at the end of IP address. •... -
Page 9: Test Print
Test Print • Using clients or distributors (.stl) file printing model will ensure the final Installation process. • Please refer Q Slicer user guide for preparing the .3dp file to insert in printer using USB or computer. Printing Requirements • Clean the building platform before starting to print . • Using alcohol or acetone, clean the building platform surface before every printing process. -
Page 10: Installation Checklist
Installation Checklist □ Inspect the printer package has any damage □ Check Accessory Box has all of the mentioned parts □ Ensure that Tank & Glass aren’t damaged while transportation □ Check if building platform is provided with printer □ Check if touch panel is working properly □... - Page 11 Support More detailed operation steps can be viewed at : https://www.youtube.com/channel/UCB-KiIG9-bINsZQS5iOV55Q...
Need help?
Do you have a question about the DentCare BQP-D15 and is the answer not in the manual?
Questions and answers