Advertisement
Quick Links
RIoT Wall Mount PIR & LDR Sensor
Setup
1. Open Enclosure
2. Insert Batteries or Connect Power
3. Activate Sensor from Standby
4. Learn Sensor to RIoT-Hub & Smartphone
5. Configure the Sensor operation as
required
Note: To achieve optimum RF Transmission,
mount the sensor ideally >1metre above ground level.
SWITCH / Menu Options
Briefly repeat press the SWITCH to select Menu 1- 4. (Indicated on the Menu LED)
Press 1x to select Menu 1 Send an immediate Learn Signal
Press 2x to select Menu 2 Activate Sensor/ Enter Standby Mode
Press 3x to select Menu 3 Enter Config mode
Press 4x to select Menu 4 Select RF Transmission Mode
Press 5x to select Menu 5 Toggle Direct Control Feature ON/OFF
After LED indicates the chosen menu, wait for Sensor to enter this menu and confirm
its current setting before making any changes.
Quick Start Guide
Light Sensor
RF Transmit
&
Menu Function
LED
QS-SENW-PIRL-1
Page: 1
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for RF SOLUTIONS SENW-PIRL-8T1
- Page 1 RIoT Wall Mount PIR & LDR Sensor Quick Start Guide Setup 1. Open Enclosure 2. Insert Batteries or Connect Power 3. Activate Sensor from Standby 4. Learn Sensor to RIoT-Hub & Smartphone 5. Configure the Sensor operation as required Note: To achieve optimum RF Transmission, mount the sensor ideally >1metre above ground level.
- Page 2 RIoT Wall Mount PIR & LDR Sensor Send a Learn Signal (menu 1) Enter Config Mode (menu 3) When Config Mode is entered the Sensor sends Briefly Press Switch its configuration settings to the App /Website to enable user to update. NOTE: Ensure you have already selected “Configure sensor”...
-
Page 3: Config Settings
RIoT Wall Mount PIR & LDR Sensor Config Settings Each of the Parameters maybe set to user requirements By default the sensor will trigger only a nighttime when the PIR is activated. Refresh Period A background “Alive” refresh signal to notify the user the sensor is OK Relay Timer Value After PIR is triggered this is the time that an RF Receiver will... - Page 4 RIoT Wall Mount PIR & LDR Sensor To Set the RF Transmission MODE (menu 4) Note that the RF Transmission Mode must Briefly Press Switch match the Riot Minhub RF Transmission! (Default is FM for both Sensor and Mini- hub) After LED Flashes Notes:...
- Page 5 RIoT Wall Mount PIR & LDR Sensor Direct Control Feature ON/OFF (menu 5) This menu is applicable only when using this Briefly Press Switch Sensor to operate a RIOT-RX receiver directly, without a RIoT Hub Gateway After LED Setting Menu 5 to LED ON enables this Sensor Flashes to be used with the RIoT-RX receiver to directly control one of the switching Relay Outputs.
- Page 6 (including liability resulting from negligence or where RF Solutions Ltd was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict RF Solutions Ltd’s liability for death or...
Need help?
Do you have a question about the SENW-PIRL-8T1 and is the answer not in the manual?
Questions and answers