Small HD Teradek Smart 7 Settings Manual

SmallHD User Manual
Teradek Settings
Bolt Monitor Modules (internal or external) can be configured using the Smart 7 Monitor's built-in
interface. Once connected, tap the TERADEK tab.
Module Configuration Menus
NOTE: Updating the SmallHD monitor to the latest firmware version is recommended before updating
the Bolt module's firmware. To update the monitor's firmware, click here, then follow the steps below to
upgrade the Bolt module.
To perform a firmware update on the Bolt Module:

1. Download the latest firmware from https://teradek.com/pages/downloads#bolt6.
2. Click the .zip download file to extract the .bin (firmware file).
3. Drag and drop the .bin file onto your SD card:
• Card must be 16 GB or smaller
• Formatted as FAT or FAT32 for Windows, MS-DOS (FAT) for macOS (if partitioned, select the
MBR Master Boot Record option under Scheme)
4. Remove the SD Card from the computer or card reader attached to the computer.
5. Insert the SD card into your SmallHD monitor.
6. Turn on your monitor.
7. Swipe/toggle left, or tap the screen to access the monitor's Settings Menu.
8. Click TERADEK, then scroll down and select UPDATE FIRMWARE.
9. Tap to select the available firmware, then follow the prompts to begin the update process.
10. Once the firmware is installed and the on-screen prompts tell you to reboot your monitor, hold
the power button for at least 5 seconds, and then release.
11. Press the power button again to begin operating your SmallHD monitor with the new firmware
installed.
Teradek Settings Page 1