Angel W-J1105-ROB8 User Manual

Dual outlet water purifier

Advertisement

Quick Links

W-J1105-ROB8 Dual Outlet Water Purifier
User Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the W-J1105-ROB8 and is the answer not in the manual?

Questions and answers

Summary of Contents for Angel W-J1105-ROB8

  • Page 1 W-J1105-ROB8 Dual Outlet Water Purifier User Manual...
  • Page 2: Table Of Contents

    ◆ It takes a few seconds for water to come out after the pure water faucet is opened. Pure water may contain some bubbles. ◆ After expiration, the filters need to be replaced by Angel's professional after-sales personnel before the purifier can be used normally.
  • Page 3: Product Introduction

    Product Introduction Purified Wastewater Pressure Filtered Water inlet water port water port drainage port tank Power Name Name Name Pressure tank port Protective housing Water inlet Wastewater drainage port Hanger Power Purified water port Filter housing Filtered water port Hanger Main Water-contacting Parts and Materials Recommended Part name...
  • Page 4: Electric Control Schematic Diagram

    Electric Control Schematic Diagram Water preparation Full water Flush Power adapter Note: The control button is subject to that on the actual product. Specifications J1105-ROB8 Model Tap water Suitable water source 41℉~100.4℉ Suitable water temperature 39.2℉~104℉ Working temperature Water inlet pressure 14.5psi~58.0psi Working pressure 58.0psi~87.0psi...
  • Page 5: Installation Steps

    Installation Steps After purchasing this device, an appointment can be made with our professional personnel for installation and debugging. Before installation, please make sure that sufficient and complete accessories are included in the package. I. Install the three-way ball valve (see Figure 1) Figure 1 1.
  • Page 6: Filter Replacement

    Filter Replacement Please contact Angel after-sales service personnel when the filter needs to be replaced. 1. Turn o ffthe power supply and the valve on the water inlet tee; 2. Clamp the inlet pipe of the pressure tank with a small pipe clamp to close the water pipeline of the pressure tank (as shown on the right);...
  • Page 7: Repair Guide

    Contact Angel after-sales service personnel for maintenance Control board failure Turn off the water source and contact Angel after-sales service personnel for repair Damaged connector seal ring Purifier leaks water Turn off the water source and contact Angel after-sales service personnel for repair Damaged filter cartridge seal ring...

Table of Contents