NAD CI 580 Owner's Manual
NAD CI 580 Owner's Manual

NAD CI 580 Owner's Manual

Bluos network music player

Advertisement

CI580
®
BluOS Network Music Player
BluOS Network Music Player CI 580
© NAD CI580v2
Owner's Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CI 580 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for NAD CI 580

  • Page 1 CI580 ® BluOS Network Music Player BluOS Network Music Player CI 580 © NAD CI580v2 Owner’s Manual...
  • Page 2: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS FOR LATER USE. NOTE TO CATV SYSTEM INSTALLER FOLLOW ALL WARNINGS AND INSTRUCTIONS MARKED ON THE AUDIO This reminder is provided to call the CATV system installer’s attention to Section 820-40 EQUIPMENT. of the NEC which provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as Read instructions - All the safety and operating instructions should be read close to the point of cable entry as practical.
  • Page 3 RECORD YOUR MODEL NUMBER (NOW, WHILE YOU CAN SEE IT) CAUTION REGARDING PLACEMENT The model and serial number of your new CI 580 are located on the back of the To maintain proper ventilation, be sure to leave a space around the unit (from the cabinet.
  • Page 4: Identification Of Controls

    Please save the box and the packaging that came with the CI 580. Should • Two detachable mains power cord you move or need to transport your CI 580, this is the safest container to • 1 piece of 6-position terminal block (for +12V TRIGGER/IR IN) use.
  • Page 5 • Connect to this USB port USB mass storage devices formatted as switch is set to OFF. This is the default setting and allows the CI 580 FAT32, NTFS or Linux ext4. The connected USB device appears as a to power up normally.
  • Page 6 The +12V TRIGGER OUT is used for controlling external equipment that is equipped with a +12V TRIGGER input. With +12V TRIGGER (ON/OFF) switch set to OFF, this output will be 12V when the CI 580 is at operating mode and 0V when it is at standby mode or powered OFF.
  • Page 7: Operation

    *** - Gross dimension includes feet, front panel Standby button and extended rear panel terminals The CI 580 specifications may be subject to change without prior notice. Check out www.nadelectronics.com for the latest specifications and features of the CI 580.
  • Page 8 All rights reserved. NAD and the NAD logo are trademarks of NAD Electronics International, a division of Lenbrook Industries Limited. No part of this publication may be reproduced, stored or transmitted in any form without the written permission of NAD Electronics International.

This manual is also suitable for:

Ci 580 v2786357000299

Table of Contents