Ronco PRO-TEC 6225 Instructions

• Ensure hands are clean and/or wear appropriate gloves while handling the mask.
Remove the respirator (mask) from its bag, inspect it for damage prior to use.
1
1. Hold respirator (mask) in one hand.
Separate top flap (panel) from bo�om.
3
3. Bring the cupped respirator towards
face, open side towards the face.
Holding the bo�om flap under the
chin, place the nosepiece (on the top
flap) on the nose, while the two head
straps hang free.
5
C
M
5. Con�nue to hold the mask on face
Y
and use the other hand to bring the
lower head strap across the crown
CM
of the head, under the ears.
MY
CY
CMY
7
K
7. Using both hands, pinch the nosepiece
un�l it falls in shape onto the nose
bridge to ensure a good fit and seal.
Ensure that the nosepiece sits
symmetrically on to the nose.
If not, repeat pinching the nosepiece
to re-adjust the nosepiece un�l it is
secured firmly.
• Repeat step 8 un�l a proper fi�ng is achieved.
1
1. Without touching the respirator,
hold the upper head strap and
remove it from the head.
3. Holding one of the head straps, without
touching the respirator cup, dispose the
respirator in accordance with local regula�ons.
The user of respirator shall check the seal of
the product immediately a�er donning.
Donning instruc�on:
2
2. Holding the top flap with one hand
(panel), separate the bo�om flap from
it to form a 3D shape.
4
4. While holding the mask on face with
one hand, use the other hand to bring
the upper head strap across the crown
of the head.
6
6. Make sure that head straps are not
twisted and follow the diagram to
ensure that they are secured correctly.
8
8. Using both hands to cover the front
of the respirator, breathe in and out
sharply to check if air leaks out around
the nose and/or at the edges. If air
leaks, adjust the nosepiece and head
straps
Doffing instruc�on:
2
2. Without touching the respirator,
hold the lower head strap and remove
it from the head.
3
Warning:
6225
Storage and transporta�on:
• Store in accordance with the instruc�ons provided on the packaging.
• Use original packaging provided when storing/transpor�ng.
• Respirators shall be stored in a manner that will protect them against dust, ozone,
sunlight, heat, extreme cold, excessive moisture, vermin, damaging chemicals, oils,
greases, and/or any other poten�al hazard that can have a detrimental effect on
the respirator.
• Respirators shall be stored in a manner that will prevent deforma�on and/or
physical damage.
Cau�ons and Limita�ons
• Before using the respirator, the wearer shall read and understand all the
informa�on provided.
• Check that the respirator is clean and in good condi�on before each use.
• Always check the manufacturing date of the respirator to make sure that the
product is not exceeding 5-year shelf life.
• This respirator is not recommended to be used with beards or other facial hair
that may compromise contact/seal between the product and skin of the face.
• Temples of eyeglasses or any other materials such as hair, cloth, �ssue, straps, or
jewellery shall not come between the skin and the sealing surface of the
respirator or interfere with the opera�on of the respirator according to CAN/CSA
Z94.4 guidelines.
• Do not use in oxygen-deficient atmospheres. CAN/CSA Z94.4 defines
oxygen-deficient atmosphere as those where oxygen concentra�on is confirmed
to be below 19.5 % (at sea level).
• Replace the respirator with a new one if it becomes damaged or breathing
resistance becomes excessive and/or intolerable.
• If a person wearing this respirator develops any condi�on that leads to
compromising the respirator seal to the face, the person shall restore the required
fi�ng in a non-hazardous environment.
• This respirator shall not be used in condi�ons and/or with atmospheric
contamina�ons which are considered Immediately Dangerous to Life or Health
(IDLH). IDLH (determined by CAN/CSA Z94.4) is an atmosphere that poses an
immediate threat to life or that will cause irreversible adverse health effects or
impair an individual's ability to escape.
• This respirator shall not be altered, modified, repaired, or cleaned.
• Do NOT use this respirator for oil-based par�cles.
• Do NOT use this respirator in condi�ons where par�cle concentra�ons exceed the
maximum allowable limit as per the applicable regula�on and standard. The
maximum allowable concentra�on is obtained by mul�plying Assigned Protec�on
Factor (APF*) and the Permissible Occupa�onal Exposure Limit (OEL) of the
contaminant. This type of disposable respirator is assigned an APF of 10 (APF=10),
which means it helps protect against certain par�cles in concentra�on up to
10 × OEL.
* APF is the an�cipated level of respiratory protec�on that would be provided by a properly
func�oning respirator or class of respirators to properly fi�ed and trained users and is used
by regulators and standards development organiza�ons, such as the U.S. Na�onal Ins�tute
of Occupa�onal Safety and Health (NIOSH) and Canadian Standards Associa�on
(CAN/CSA Z94.4 Selec�on, use, and care of respirators).
Do NOT wear a respirator that cannot pass the seal checks successfully.
6225
Warning: