Subscribe to Our Youtube Channel
Summary of Contents for USX-MOUNT XAS506
- Page 1 XAS506 INSTRUCTION MANUAL If you have any questions along the way, just message to us. We’re ready to help! USA-C1...
- Page 2 CAUTION: PLEASE READ ENTIRE MANUAL PRIOR TO USE AND SAVE THESE INSTRUCTIONS. Before getting started, let’s check below lists to make sure it is just right for you! CAUTION: DO NOT exceed the maximum weight Does your No? Perfect – you may continue. indicated.
-
Page 3: Top View
Dimensions FRONT VIEW SIDE VIEW 330mm [12.99in] ∅ 35mm [1.38in] ∅ 42mm [1.65in] 1057.5mm 817mm [41.63in] [32.17in] TOP VIEW SPEAKER ATTACHMENT UNIT FRONT VIEW Ø7mm [Ø0.28in] 240mm [9.45in] 330mm 309.5mm [12.99in] [12.18in] 240mm [9.45in] 20.5mm [0.81in]... -
Page 4: Parts And Hardware
Parts and Hardware WARNING: This product contains small items that could be a choking hazard if swallowed. Before starting assembly, verify all parts are included and undamaged. If any parts are missing or damaged, do not return the damaged item to your dealer; contact Customer Service. - Page 5 Parts and Hardware for STEP 1 G---M6 Carpet Nut F---M6 Carpet Nail 8 pcs 8 pcs A---Base B---Bottom tube 2pcs 2pcs H---M6X12 bolt I---M6X8 bolt 2pcs 8pcs J---Allen key D---Speaker attachment C---Adjusting tube unit 2pcs 2pcs...
- Page 6 STEP 1 Assemble Product 1-1 Insert bottom tube (B) into base (A), then fasten bolt (I) by using Allen key (J). Option: If the stand is placed on carpet, spin to loosen and remove the rubber feet, install the carpet nail (F) and screw to the end, then use the nut (G) to tighten the nail.
- Page 7 1-2 Insert Adjusting tube (C) into bottom tube (B) and use Allen key (J) to fasten bolt (I).
- Page 8 1-3 Attach the Speaker attachment unit (D) to the Adjusting tube (C) and fasten it with bolt (H). Wire...
- Page 9 Step 2 Attach speaker to assembled stand Option 1: According to your speaker's installation hole, choose bolt L/M,washer(P) and spacer (Q) (as shown in Figure 1 and 2) to attach it.Then plug the wires. For screw hole on flat panel: Use bolt (L/M), washer (P) For inset hole: Use bolt (L/M), washer (P) and spacer and spacer (Q) to attach the speaker.
- Page 10 Option 2: For speaker with a key hole,attach key hole bolt (N) to the speaker attachment unit (D) with butterfly nut (O).
- Page 11 Place speaker on stand with key hole bolt (N) inserted in the key hole, then tighten the butterfly nut (O) and plug the wires.
- Page 12 Option 3: Speaker with a wooden base and has no mounting holes at all. Use wood screws (NOT provided in the package) to mount the speaker. Mark the installation holes' position on the bottom of the speaker and drill holes, then attach the speaker onto speaker stand.
-
Page 13: Height Adjustment
Step 3 Height Adjustment Loosen the handle, and adjust the tube (C) to desired height , then tighten the handle. MAN:1071mm [42.17in] Tighten MIN:817mm [32.17in] Loosen...
Need help?
Do you have a question about the XAS506 and is the answer not in the manual?
Questions and answers