IP Power NIT-C5332-AW28 Quick Start Manual

Network Camera
Quick Start Guide
■ Please read this instruction carefully before operating the unit
and keep it for further reference.
■ All the examples and pictures used here are for reference only.
■ The contents of this manual are subject to change without
notice.
1
Warning and Caution
■ If the product does not work properly, please contact your dealer or the
nearest service center. Never attempt to disassemble the camera yourself.
(We shall not be responsible for any problems caused by unauthorized
repair or maintenance.)
■ Do not allow water or liquid intrusion into the camera.
■ In the use of the product, you must be strict compliance with the
electrical safety regulations of the nation and region. When the product is
mounted on wall or ceiling, the device shall be firmly fixed.
■ Do not use camera beyond specified voltage range.
■ Do not drop the camera or subject it to physical shock.
■ Do not directly touch the camera when installing.
■ The product must be grounded to reduce the risk of electric shock.
■ You must wear anti-static gloves or discharge static electricity before
removing the lower dome.
■ Avoid touching the camera lens.
■ If cleaning is necessary, please use clean cloth to wipe it gently.
■ Avoid aiming the camera directly towards the sun or other bright objects.
■ Do not place the camera in extremely hot, cold (the operating
temperature shall be -30˚C~60˚C), dusty or damp locations, and do
not expose it to high electromagnetic radiation.
■ To avoid heat accumulation, good ventilation is required for operating
environment.
2
Package
Camera Quick start guide
CD
Drill template
(optional)
Rubber plug
Screwdriver
3
Overview
1
1
2
2
3
3
4
4
5
5
DC12V
* 1 It is recommended to install the water-proof connector for outdoor installation.
* 2 Hold and press the reset button for 10s to reset to the factory default setting after the
device is started.
Connecting Network Cable
Tapping screws × 4
1
×4
Plastic plug
① Loosen the nut from the main element.
② Run the network cable (without RJ 45 connector) through the
both elements. Then crimp the cable with RJ 45 connector.
③ Connect the cable to the Ethernet connector. Then tighten the
nut and the main cover.
4
Installation
Ethernet connector
Please make sure that the wall or ceiling is strong enough to
Audio input
withstand 3 times the weight of the camera. Please install and use
Power connector the camera in a dry environment. You'd better install back the lower
dome less than 4 hours after removing it. Do not remove the protection
Micro SD Card Slot
film until finishing the installation.
Reset
① Attach the drill template to the place where you want to fix the camera
and then drill the screw holes and the cable hole on the wall according
to the drill template.
② Rotate the trim ring anticlockwise to remove it from the camera.
Trim ring
2 3
74.3
(mm)
74.3