Uni-Com 63810 Operating Instructions

Directions for use
Important before use - open the battery cover on the back of the remote control and remove the battery tab.
Resetting the socket so it can be paired on a different channel
(1) Turn the power off and on at the mains socket.
(2) Press and hold the ALL OFF button on the remote control - the red LED on the front of the socket will flash
quickly. Keep holding the button until the red LED turns off.
(3) The socket has been reset.
N.B. In the event of a power cut the red LED on the front of the sockets will flash when the power is restored.
Do not touch any buttons on the remote control until the red LED stops flashing, this will retain your
existing pairings you have previously set up.
Battery replacement - remote control
When the red LED on the front of the remote control does not light when you press one
of the buttons the batteries will need replacing.
(1) On the back of the remote control slide the battery cover down and lift to open.
(2) Insert 2 x AAA batteries, observing the polarity markings.
(3) Refit the battery cover.
Remote control sockets
Model: 63810
Operating instructions
(1) Plug a socket into the mains socket and switch on - the red LED
will flash on the front of the socket.
(2) Press the A ON button on the remote control - you will hear the
relay in the socket click and the red LED will stop flashing. The
socket will be paired to channel A on the remote control.
(3) Press the A OFF button on the remote control - the red LED will
turn off.
(4) Plug your appliance into the front of the socket and you can now
use the remote control A buttons to turn the appliance on and off.
(5) Repeat the above process to set up multiple sockets on channel
A or each socket on a different channel by pressing B, C or D
instead of A when following the above instructions.
(6) All sockets can also be turned on and off simultaneously using
the ALL ON and ALL OFF buttons on the remote control.
Instructions continue overleaf - please turn over