Advertisement
Quick Links
Advertisement
Related Manuals for ALOE CARE HEALTH Entry Sensor
Summary of Contents for ALOE CARE HEALTH Entry Sensor
- Page 1 Entry Sensor Setup & Install Aloe Care...
- Page 2 Help Is Here Contents Reach out to us for assistance with setup or 1. Your Entry Sensors answers to general questions; one of 2. Insert the Batteries our team members will be happy to help. Call, email, or visit us online— 3.
- Page 3 One Set Meet Your New Entry Sensors Unpack the two sets of Entry Sensors and lay the items out on a table for easy setup. Collect your items— 1. Sensor 2. Magnet 3. AAA Batteries...
- Page 4 Insert the Batteries Find the circular tab on the edge of the Entry Sensor casing and press it to separate the front and back panels. Insert the two AAA batteries into the front panel, making sure the negative poles touch the springs.
- Page 5 Follow the in-app instructions to finish pairing. Repeat the process for the other Entry Sensor. Make sure sensors are near the Smart Hub when pairing. The red LED will stop flashing when successfully paired.
- Page 6 Hinged Door Mount Find a spot (opposite the hinges/ pivot point) where the sensor element can fit on the doorframe, and the magnet can fit on the door, making sure the two pieces will be no more than 5mm apart. Vertical Peel the tape cover off the back Mount...
- Page 7 Sliding Door Mount (Horizontal) Horizontal Mount Find a spot where the sensor can fit on the doorframe, and the magnet can fit on the door, making sure the two pieces will be no more than 5mm apart when the door is closed. Peel the tape cover off the back of the sensor and attach it to the doorframe, then attach the magnet...
- Page 8 Reset the Device A device reset may be necessary to eliminate abnormal behavior. 1. Press and hold down the reset button (small ring on the front) for 8-10 seconds. 2. While holding the button down, the LED blinks once, then twice, Reset Button then continuously.
- Page 9 Aloe Care Health, Inc. Copyright © 2020 Aloe Care Health...
Need help?
Do you have a question about the Entry Sensor and is the answer not in the manual?
Questions and answers