FSM DPC Operation Manual

Translated from German to English - www.onlinedoctranslator.com
> operation manual
Pressure calibrator | Type DPC
Hints
>
To avoid damage, please read the operating instructions carefully before using.
>
The permissible maximum pressure must not be exceeded: DPC 1/ DPC 10/ DPC 100 5-fold overload; DPC 1000 2x
overload
>
The calibrator is able to exceed or fall below the target pressure specification by +/- 10%
>
The device may only be opened by qualified personnel from FSM AG.
Operating modes
The device has a total of four different operating modes.
operation mode
CTRL (control)
MESS (measure)
AUTO (automatic)
MENU
service
>
I/O: Button for switching the device on and off
>
MENU: This button takes you to the setup menu and allows you to make the settings for the respective operating mode.
When using CTRL mode, the device is in VENT mode after exiting the setup menu.
>
LEAK: With the LEAK button, a test item connected to the calibrator can be checked for leaks.
>
ZERO: Button for manual zeroing of the integrated sensor
>
UP: In CTRL mode to set the absolute and percentage value. In MENU mode to switch to the various submenu items.
>
DOWN: In CTRL mode to set the absolute and percentage value. In MENU mode to switch to the various submenu items.
>
OK: The OK button can be used to switch between absolute and percentage value in CTRL mode. In MENU mode, the
button is used to confirm the respective setting. The AUTO mode is started using the OK button.
>
%:In CTRL mode you can use the % key to change the value from -100% to 100%. In the submenu for setting the decimal
places.
>
You can see the status of the integrated battery and power supply at any time in the display (bottom left)
FSM AG
Erich-Rieder-Strasse 2
D-79199 Kirchzarten
Application
Calibration of sensors and other test
items
Measurement of differential and relative pressure.
Pressure profiles stored in the device are
executed.
Specific adaptation to the respective
application.
+ 49 7661 9855 0
vertrieb@fsm.ag
function
Pressure is built up and maintained.
Specification can be percentage or absolute.
Electronics evaluate the pressures present at
the device.
The pump builds up different pressures based
on the stored pressure profiles.
Setup function for the different
operating modes.
1|6
www.fsm.ag