Talkaphone ETP-520 Series Quick Installation Manual

I. Introduction
This Quick Installation Guide provides instructions for installation of the ETP-520 Call Station. It is
recommended to read this guide completely before starting any installation.
II. Contents
Please ensure receipt of each of the included ETP-520 Call Station components:
QTY
1
6
III. Tools Required
Tools required for installation are not provided and are as follows:
Part Number
42938
Page 1 of 9
Copyright 2023-2024 Talk-A-Phone, LLC • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • info@talkaphone.com • www.talkaphone.com
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, ECO TOWER, and WEBS are registered trademarks of Talk-A-Phone, LLC. All
rights reserved. All other trademarks mentioned in this document or website are the property of their respective owners and does not imply or indicate any approval,
endorsement, sponsorship, or affiliation with such owners unless such approval, endorsement, sponsorship, or affiliation is expressly indicated.
Part Number Description
ETP-520 Series Analog Call Station
#10-24 x 3/4" L, Stainless Steel, Flat Head,
42935
Pin-in Torx (T-20), Tamper Resistant Screws
Description
Pin-in torx (T-20) bit, 1/4-inch shank, for #10 screws
5/16-inch hex nut driver
Wire cutter/stripper
Wire nuts (twist-on connectors), Dolphin connectors, or
"beanie" connectors for 24-22 AWG wire
ETP-520 Series Analog Call Station
Quick Installation Guide
Rev. 9/18/2024