Table of Contents
Advertisement
Connecting and Configuring Your Message Manager
Connecting your Message Manager to a Router/Gateway
Option 1 – Installing the Message Manger as a client to a router
that already exists.
connected to your cable/DSL broadband modem.)
1.
Identify an available LAN port on your exiting router or
home gateway.
2.
Using the Cat-5 Ethernet cable that is included with your
Message Manager, take one end of the Cat-5 cable and connect
it to the available LAN port on your Router. Connect the opposite
end to the WAN port on the Message Manager.
3.
Connect a standard analog phone to the Phone Port of the
Message Manager. You may also connect the Message Manager
to your Telephone line if desired. This is optional and is
not required.
4.
Locate the power supply that is included with your Message
Manager. Plug the power supply's small connector into the DC
power jack the Message Manager. Plug the power supply into an
empty power outlet.
5.
The Message Manager automatically connects to the Internet.
The WAN LED will blink green to indicate that there is and
Internet connection.
6.
Wait up to 5 minutes while the Belkin Message Manager
automatically registers to the Belkin callEverywhere center.
7.
Once a connection to our callEverywhere center is established,
the phone connected the Message Manager will ring confirming a
connection was established.
8.
Answer the call and follow the on-phone instructions. You will
be directed to go to the following website to sign up for your
service: www.everywhere.net
(Select this option if you already have a router
11
11
1
2
3
4
5
6
7
8
9
10
11
12
Advertisement
Table of Contents
