Save Changes - Asus UL30A Hardware User Manual

A
Appendix
System BIOS Settings (cont.)
Password Check
Select whether to ask for
a password during bootup
(Always) or only when
entering the BIOS setup
utility (Setup).
User Access Level
Select the level of access
to allow the "User Pass-
word" to have in the BIOS
setup utility.

Save Changes

If you want to keep your
configuration settings, you
must save changes before
exiting the BIOS setup
utility.
If you want to restore
default settings, choose
Load Setup Defaults. You
must then save changes
to keep the manufacture
default settings.
A-8
Security
Security Settings
Supervisor Password : Installed
User Password : Installed
Change Supervisor Password
User Access Level
Change User Password
Clear User Password
Password Check
Hard Disk Security Setting
I/O Interface Security
v02.59 (C)Copyright 1985-2005, American Megatrends, Inc.
Security
Security Settings
Supervisor Password : Installed
User Password : Installed
Change Supervisor Password
User Access Level
Change User Password
Clear User Password
Password Check
Hard Disk Security Setting
I/O Interface Security
Trusted Computing
v02.59 (C)Copyright 1985-2005, American Megatrends, Inc.
Main Advanced Security Power Boot Exit
Exit Options
Save Changes and Exit
Discard Changes and Exit
Discard Changes
Load User Defaults
Load Manufacture Defaults
v02.59 (C)Copyright 1985-2005, American Megatrends, Inc.
BIOS SETUP UTILITY
[Full Access]
Options
[Setup]
Disabled
Enabled
BIOS SETUP UTILITY
[Full Access]
Options
No Access
[Setup]
View Only
Limited
Full Access
BIOS SETUP UTILITY
Setup: Check password
while invoking setup.
Always: Check password
while invoking setup
as well as on each
boot.
Select Screen
Select Item
Enter Change
F1 General Help
F10 Save and Exit
ESC Exit
Setup: Check password
while invoking setup.
Always: Check password
while invoking setup
as well as on each
boot.
Select Screen
Select Item
Enter Change
F1 General Help
F10 Save and Exit
ESC Exit
Exit system setup after
saving the changes.
F10 key can be used for
this operation.
Select Screen
Select Item
Enter Go to Sub Screen
Tab Select Field
F1 General Help
F10 Save and Exit
ESC Exit