Green Brook Sol Series Installation Instructions

Part Nos
Daylight
LEDFL10B, LEDFL20B, LEDFL30B, LEDFL50B, LEDFL100B,
6,500K
LEDFL150B, LEDFL200B
Warm White
LEDFL10BWW, LEDFL20BWW, LEDFL30BWW, LEDFL50BWW,
3,000K
LEDFL100BWW, LEDFL150BWW, LEDFL200BWW
This product should be installed by a competent person and
These instructions should be read carefully prior to any installation and retained
after completion for further reference and maintenance. Please give these
instructions to the building owner/occupier after installation.
Always turn off the power source before commencing work on this device
INSTALLATION DIMENSIONS - FIGURE A (Unit:mm)
180°
180°
The 'Sol' range are water resistant to IP65 (PIR IP44) but it is advisable, to locate it
in a sheltered location. No modification should be made to the casing to pre-
serve the moisture properties and warranty.
This appliance comes with a flex lead and this can not be removed or replaced.
The flex should be connected to a waterproof connector for outside locations.
To avoid a heat build up a clear air gap around the luminaire and the front face
should be at least 500mm away from any combustible surface. The supplied
bracket should be used at all times for mounting.
'Sol' LED Slimline Floodlights Range
Non PIR Fittings
IMPORTANT INFORMATION
in accordance with the IET Wiring Regulations.
If in doubt, consult a qualified electrician.
L1
L2
Wattage L1mm
35
10W
20W 50
62.4
30W
55
50W
105
100W
114
150W
200W 114
POSITIONING OF FITTING
INSTALLATION INSTRUCTIONS
Installation Instructions for:-
Daylight - 6,500K
Warm White - 3,000K
Position of
fixing holes
on bracket
Figure A
L2mm Ø1mm Ø2mm
54 6.5
94 7.8
115 7.5
124 12.8
174 12
166 12
166 12
PIR Fittings
LEDFLPIR10B, LEDFLPIR20B,
LEDFLPIR30B, LEDFLPIR50B
LEDFLPIR10BWW , LEDFLPIR20BWW,
LEDFLPIR30BWW, LEDFLPIR50BWW
5.5
6.2
7.8
10.2
10
10
10