Advertisement

1
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PanelMate 1700 Series and is the answer not in the manual?

Questions and answers

Summary of Contents for ATS PanelMate 1700 Series

  • Page 2: Installation

    NON-HAZARDOUS. will severely shorten the unit's life. Refer to ATS's PanelMate Installation Guide for installation recommendations. The Guide is available on the ATS web site: www.buypanelmate.com Panel cutout dimensions and stud torque limits are RISQUE D'EXPLOSION. COUPER LE COURANT shown on the reverse side of this Express Setup sheet.
  • Page 3 Connections Connect DC Power Connection to a Personal Computer Your PanelMate unit is designed to operate at Executive firmware and PanelMate configurations 24VDC -15%/+20%. A removable three-position DC are uploaded/downloaded to a personal computer power connector attaches to the unit's connector using the PanelMate unit's serial port.
  • Page 4 Series unit or a Power Series 1500 unit, and are using an RS422 or RS485 cable for PLC communications, you may need to install a new cable equipped with a ground wire. Consult your PLC communications driver manual or contact ATS Technical Support for more information.
  • Page 5: Tests & Adjustments

    Tests & Adjustments PanelMate Diagnostic Tests Display System Configuration Information This selection displays your PanelMate unit's When power is applied to your PanelMate unit, the current configuration. Your PanelMate unit is unit will display a listing of internal diagnostic shipped with a demonstration PanelMate checks as they are executed.
  • Page 6: Touchscreen Information

    Touchscreen Information Touchscreen Calibration PanelMate Operation You can calibrate your unit's touchscreen in both The most basic job of a PanelMate unit is to replace Offline and Run modes. To access the calibration the functions of hard-wired operator station devices screen when in Offline mode, select the Calibrate such as pushbuttons, lamps and message displays.
  • Page 7: Cutout Template

    Cutout Template Care should be taken when tightening the The reproduction process may distort this nuts. The fasteners must be tightened cutout template. Always check your dimensions enough to obtain a proper seal, but not over prior to cutting your panel. tightened to the point where the threads are stripped or the gasket is rendered useless.
  • Page 8: Specifications

    Specifications Temperature Operating: 0 to 50 degree C (grayscale & TFT color) 0 to 40 degree C (dual-scan color) Non-Operating: -20 to 60 degree C Humidity (non-condensing) Operating: 20% - 80% (grayscale) 20% - 90% (color) Non-Operating: 20% - 90% (grayscale) 20% - 95% (color) Installation Rating: Type 4, Type 4X, or Type 12, when properly...
  • Page 9 ATS didn't earn its reputation for making factories run better by accident. We earned it by proving ourselves in some of the most advanced and demanding factories in the world. Our breadth of expertise stretches much farther than Legacy Products.

This manual is also suitable for:

Panelmate powerpro

Table of Contents