Fusing - Bose Direct/Reflecting 901 III Series Owner's Manual

e. Connect the " + " terminal on the left speaker to the termi¬
nal marked' pos. 'positive." or plus'' on the left channel
output of the amplifier or receiver
NOTE: Use only the terminals marked " T" and " " The
terminal marked is intended for future electronic de¬
velopments and should
nol
be used with conventional
amplifying equipment
f Place the speaker marked Part 2 on the right side of the
room and repeat the connection procedure for the right
amplifier channel.
g If you are using an amplifier rated at over 100 watts rms
per channel, fuse your speakers as outlined in SECTION 3
3. Fusing
Any loudspeaker issubjecttodamageiflheamplifier powering
it should fail The use of a fast-acting fuse in series with each
speaker will minimize the possibility of serious damage to your
speaker
For amplifiers rated at under 100 watts rms per channel, no
fusing is required Amplifiers rated over 100 watts per channel
should be fused with a fast-blow. 3-amp fuse
Purchase fuseholders and the appropriate fast-acting fuses
Connect the fuseholders in series with the positive wire going
to each speaker, placing the fuse in an easily accessible
location.
BOSE Corporation recommends the use of the Buss AGC
Series or the LittlefuseAGSeriesasspeaker fuses
9