Priority e-Classic Plus Quick Start Manual

Download this manual

Riding the Priority e-Classic Plus

Starting Out

The e-Classic Plus was designed for adult use only. To turn on your bicycle, press the power button before you start riding. Give

the bicycle a moment to turn on before riding. When the bicycle turns on, it will be on pedal assist level 0. This allows you to

ride it like a standard bicycle. We recommend visiting any reputable bicycle shop for a safety check before embarking on your

first adventure! If you carefully flip your bike upside down, you will see a serial number engraved into the frame. Write this

down and keep it in a safe place.

Display

The largest number in the middle is your current speed. On the top right, you will see a small box that states "Assist". This

indicates your pedal assist level. At zero, your pedal assist is off, and you can ride the bicycle without the motor. Use the "+"

and "-" button to cycle through the pedal assist levels. Levels 1- 3 allow the motor to contribute power as you pedal.

A short press on the power button will cycle through the different metrics on the bottom right:

• Trip Distance: Refers to your total distance during your trip.

• Odometer: This is your total mileage (you cannot reset this number)

• Range Est: This is a rough estimate of your battery life in miles. This will fluctuate during your ride.

Pedal Assist

The e-Classic Plus is a pedal assist bicycle. This means the motor will only provide power if you are pedaling. To use the pedal

assist, press the " + " button on the top left of the display and begin pedaling. On your display, you will see three pedal

assistance levels. As you go up from 1-3, your motor will provide more power when pedaling. Squeezing the brakes will

immediately cut power from the motor until the brake is released and the bicycle senses you are pedaling again.

Walk Assist

Walk assist mode will give you a boost when walking beside the bike. With the bicycle in pedal assist level 0, press and hold the

" – " button. The bicycle will maintain 1.5mph while the button is held. To stop the walk assist, release the " – " button.

Need help?

Do you have a question about the e-Classic Plus and is the answer not in the manual?

Page 1 Pedal Assist The e-Classic Plus is a pedal assist bicycle. This means the motor will only provide power if you are pedaling. To use the pedal assist, press the “ + “ button on the top left of the display and begin pedaling. On your display, you will see three pedal assistance levels.
Page 2 P2 Dictates the maximum speed for the motor’s pedal assist. You can ride the bicycle faster than the 20mph speed limit, but the motor will stop providing power beyond this speed. P3 Sets the bicycle's wheel size. For the e-Classic Plus this setting should be 700. P4 Sets the display’s brightness.
Page 3 Charging and Storing the Priority e-Classic Plus Battery The e-Classic battery is designed to charge both on and off the bicycle. On the underside of the battery is the charging port. On the side of the battery is a lock. You don’t need the key to install the battery; the key is used to remove the battery from the bicycle. To remove the battery, turn your key in the lock and pull your battery forward and out of the bicycle.
Page 4 It accurately lets you know the tension of your belt, allowing you to adjust as needed. For the e-Classic Plus, we recommend between 45 - 65 Hz. Aim for the lower end of this range, unless you are a heavier rider or are using a lot of gear.