Labona ISOTRA CLASSIC Measurement And Assembly Manual

MEASUREMENT AND ASSEMBLY MANUAL
ISOTRA SYSTEM - CLASSIC, HIT, HIT II
Rectangular window Untypical window
1. MEASUREMENTS
Isotra system blinds are designed for assembly into the window wing of plastic and wooden Euro windows.
The width and height are measured in the following manner:
w.... (width)
The measurement is taken at the glass from the left inside edge of the glazing bar to the right inside edge of the glazing
bar, including the rubber or silicon sealing in three places – up, middle and down. For manufacturing and ordering the
blind, the minimum measured dimension is stated.
The width of the blind is produced with the precision of millimetres from the width 300 mm to 2000 mm with a tolerance of
± 1 mm.
h .... (height)
The measurement is taken at the same depth of the glazing bars as the width of the blind, from the upper bar to the lower
bar.
The height of the blind is produced
with the precision of millimetres from the height of 300 mm up to 2200 mm with a tolerance of -3 / +27mm.
d .... (depth)
The depth of the glazing bar is measured in relation to the use of the distance bases under the side board for the blinds.
There is a left and right base.
Validity of the manual: 1. 9. 2014
1