Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for JUNO JSI5562E
Summary of Contents for JUNO JSI5562E
- Page 1 Geschirrspüler Dishwasher JSI 5562 Gebrauchsanweisung Instruction booklet...
-
Page 2: Important Safety Information
Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information. -
Page 3: Table Of Contents
Something not working Protection against flooding Service and spare parts Guide to use the instrucion book The following symbols will be found in the text to guide you throughout the instructions: Safety instructions Step by step instructions Hints and tips... -
Page 4: Description Of The Appliance
Description of the appliance IN66 1. Water hardness adjustment 10. Rinse aid dispenser 11. Large filter 2. Levelling spacers 3. Upper basket stop 12. Central filter 4. Door balancers 13. Upper spray arm 5. Salt container 14. Upper basket 6. Lower spray arm 7. -
Page 5: The Control Panel
(see "Washing correct programmes. programmes" chart). 4. Door handle To open the door press the catch in the top of the recess and pull the door toward you at the same time. To close the door simply push it. -
Page 6: Before Use
Water Authority can advise you on the hardness of the water in your area. The dishwasher is factory set at level 2. If this level is not suitable for your area the softener should be adjusted. To adjust the water softener:... -
Page 7: Filling With Salt
Filling with salt If your water is "level 0" it is already soft and therefore there is no need to use salt. Salt must be used from level 1 upward. Only use salt specifically designed for use in dishwasher. All other types of salt not specifically designed for use in dishwasher, specially table salt, will damage the water softener. -
Page 8: Rinse Aid
BR03 Adjusting the dose According to the finish and drying results obtained, adjust the dose of rinse aid by means of the 6 position selector (C) (position 1 minimum dosage, position 6 maximum dosage). (Start from position 3). Gradually increase the dose if there are drops of water or lime spots on the dishes after washing. -
Page 9: Use Of Detergent
65°C programmes and conventional detergents. These new compact powders are generally phosphate-free. As phosphates have water softening properties, we suggest you add salt to the salt container even if the hardness of your water is as low as 4°dH (7°TH). -
Page 10: Using Your Appliance
Do not load very small items which can fall through the baskets. Open the door and slide out the baskets to load the dishes. The lower basket IEC 436 / DIN 44990... -
Page 11: Adjusting The Height Of The Upper Basket
Adjusting the height of the upper US29 basket If washing very large plates (over 27 cm and up to 31 cm in diameter) you can load them in the lower basket after moving the upper basket to the higher position. -
Page 12: Hints And Tips
Aluminium tends to go black, copper, pewter and brass tend to stain. Wait a few minutes before removing the dishes; in this way they will be cooler and the drying will If in doubt check with manufacturer of the be improved. -
Page 13: Washing Programmes
25 g in the dispenser 5 g on the dispenser lid. This is a special programme for quick washing (approx. 40 minutes) a full load of lightly soiled dishes, glasses and crockery (except pots) so that you may re-use them promptly. -
Page 14: Operating Sequence
Close the detergent dispenser In general it is not advisable to open the door while the machine is working; if the door is opened however, a safety device ensures that the machine stops. -
Page 15: Maintenance And Cleaning
(A) and should be removed by rinsing the filter under running water. To remove the drain filter: simply pull it out by the handle. Once cleaned, refit the filter by pushing it back to its original position until it engages. Cleaning the large filter MA04... -
Page 16: External Cleaning
Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc..). Prolonged periods of non-operation If you are not using the machine for any period of time you are advised to: 1. Unplug the appliance and then turn off the water;... -
Page 17: Something Not Working
Something not working Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Force Centre, please carry out the checks listed below. Symptom Solution The machine will not start The door has not been properly closed. -
Page 18: Protection Against Flooding
If after all these checks, the problem persists, contact your local Service Force Centre, quoting the model and serial number. This information can be found on the rating plate located on the right hand side of the dishwasher door (see picture). Protection against flooding In order to prevent water floods, the machine has Prod.No. -
Page 19: Installation Instruction
Installation instruction Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. Any plumbing work required to install this appliance should be carried out by a qualified plumber or competent person. -
Page 20: Water Supply Connections
Your local Water Authority will advise you on the average mains pressure in your area. The dishwasher features fill and drain hoses which can be turned either to the left or the right to suit the installation. The locknut must be correctly fitted to avoid water leaks. -
Page 21: Water Outlet Hose Connection
The waste connection must be at a height of between 30 cm (minimum) and 100 cm (maximum) from the bottom of the dishwasher. The drain hose can face either to the right or left of CS13 the dishwasher Ensure the hose is not bent or squashed as this could prevent or slow down the discharge of water. -
Page 22: Building-In
It is essential that the recess dimensions indicated in the diagram are followed. No further openings for venting of the dishwasher are required, but only to let the water fill and drain hose and power supply cable pass through. The recess height may be anywhere between 820 and 880 mm from the floor since the dishwasher incorporates adjustable feet (max 60 mm). -
Page 23: The Furniture Door
On the panel sign the seats for the four fastening II22 screws. Drill the panel with a Ø 2 x 12 bit and fix the supporting cross-bar onto the wooden panel with the 3.5 x 16 screws provided. -
Page 24: Fitting The Vapour Protection
Secure the brackets to adjacent units with the 3.5 x 16 screws using the upper or the side holes. The appliance must be secured to the underside of the worktop using the brackets provided. -
Page 25: Noise Protection
II15 Height (a)* 1 7 0 1 6 0 1 5 0 1 4 0 1 3 0 1 2 0 11 0 1 0 0 136 131 125 118 110 100 93 85 135 131 125 118 110 102 92 85... - Page 28 152989 36/0 0/0598...