1. Manuals
  2. Brands
  3. Tachyon Manuals
  4. Switch
  5. TNS-100
  6. Operating manual

Tachyon TNS-100 Operating Manual

Hide thumbs
1
2
3
4
5

Advertisement

Table of Contents

26/09/2023, 12:13
TNS-100 Operating Manual
Modified on: Tue, 1 Aug, 2023 at 11:22 AM
This operating manual applies to the TNS-100 product model.
Table of contents
Product box contents
Powering your device
Device access for initial configuration
Basic configuration
Troubleshooting
Updating firmware
Resetting your device
Product box contents
Please consider recycling our eco-friendly product packaging.
Item
TNS-100 6-port 2.5G PoE Switch
DIN rail mount
Quick start guide insert
Barrel jack to 2-wire DC adapter
Powering your device
Input Power
i Important Notes
The input power should be 24-57VDC and a minimum of 15W is recommended to power the switch.
Negative (-) V input is not currently supported.
TNS-100 devices can not be powered by active PoE (802.3at, etc). Only passive PoE is supported.
PoE Out on the TNS-100 will have the same voltage as the input voltage. Only 4-pair PoE Out is
supported.
https://tachyon-networks.freshdesk.com/support/solutions/articles/67000719583-tns-100-operating-manual
Tachyon Networks TNS-100 PoE Switch Operating Manual : Support & Learning Portal
Qty
1
1
1
1
1/5

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TNS-100 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Tachyon TNS-100

  • Page 1 Negative (-) V input is not currently supported. TNS-100 devices can not be powered by active PoE (802.3at, etc). Only passive PoE is supported. PoE Out on the TNS-100 will have the same voltage as the input voltage. Only 4-pair PoE Out is supported.

  • Page 2: Output Power

    Output Power The TNS-100 has the ability to send passive PoE out of 4 of the 2.5Gbps ports (ETH1-4) to power other devices using the input power provided to the TNS-100. These settings can be found under the Settings -> Interfaces section of the Web UI.

  • Page 3: Basic Configuration

    UI. manual#interface) Additional Configuration Settings For information about the additional configuration settings, please refer to the the TNS-100 web UI manual (https://tachyon-networks.freshdesk.com/support/solutions/articles/67000719614-tns-100-web-ui-manual) Troubleshooting your TNS-100 Please take the following steps to troubleshoot any devices that have sub-optimal performance: 1.

  • Page 4: Updating Firmware

    All TNS-100 series devices have two bootbanks. In the event that a firmware upgrade fails (power flicker, etc) and the device cannot boot up, it will revert back to the firmware flashed on the previous bootbank.
  • Page 5 26/09/2023, 12:13 Tachyon Networks TNS-100 PoE Switch Operating Manual : Support & Learning Portal 1. Reset button: Find a paperclip, or something similar, and use it to press and hold the physical reset button on the device for 20 seconds or more. This will not have any affect if the reset button is disabled in software.

Table of Contents