Download Print this page

Hofmann LUM005 Quick Start Manual

Headlamp beam setter

Download this manual

LUM005

Headlamp beam setter

Need help?

Do you have a question about the LUM005 and is the answer not in the manual?

Page 1 LUM005 Headlamp beam setter...
Page 3 IMPORTANT: If floor is not totally flat, please put shims under the rails.
Page 4 PUSH...
Page 6 30 s. CAUTION LASER RADIATION DO NOT STARE INTO BEAM POWER OUTPUT < 1mW WAVELENGHT: 630-680 nm CLASS II LASER PRODUCT AVOID EXPOSURE - LASER LIGHT IS EMITTED FROM THIS APERTURE...
Page 7 30-50 cm CAUTION LASER RADIATION DO NOT STARE INTO BEAM POWER OUTPUT < 1mW WAVELENGHT: 6 30-680 nm CLASS II LASER PRODUCT AVOID EXPOSURE - LASER LIGHT IS EMITTED FROM THIS APERTURE 30 s.
Page 8 30 s. L1 = L2...
Page 9: High Beams
LOW BEAMS (AND FOG LAMPS) BEAM DIRECTION AND HEIGHT Before to proceed to the beamsetting, it is important to know its height. It is measured from the center of the light to the floor. If the beam's height is less than 850 mm. it must be adjusted between 0,5% and 2% slope. If it is more than 850 mm, between 1,25% and 2,75%.
Page 10 2x1,5V. AA 9V. 6F22 CALIBRATION Headlamp Height 0-850 mm Kick-Up Limit 0,5% 1,25% 2,75% laser line has to meet 0% line Headlamp Height >850 mm AUTO LEVELLING LASER...
Page 12 Snap-on Diagnostics Denney Road, King's Lynn Norfolk PE30 4HG snapon-equipment.co.uk...