Subscribe to Our Youtube Channel
Summary of Contents for Truper CORSOL-T
- Page 1 Manual Cutting and welding outfit Heavy duty CORSOL-T Applies for: Code Model 102972 CORSOL-T Read this manual thoroughly CAUTION before using the tool.
-
Page 2: Table Of Contents
Pressure adjustment its entirety before using the tool. Cutting operation Keep this manual for future references. Troubleshooting The illustrations in this manual Notes are for reference and may differ from the real appearance of the tool. CORSOL-T CORSOL-T ENGLISH... -
Page 3: Safety Warnings
Safety warnings WARNING There are many risks associated with the use of oxyacetylene welding. It is necessary to take appropriate safety measures when working with this equipment. Work area Connections WARNING • Before welding or cutting, ensure that the work area is in •... -
Page 4: Parts
Parts Welding goggles shade #6 Acetylene regulator Oxygen regulator Regulator with safety valve with safety valve knob Regulator knob Flame arrestor Brass and stainless steel cutting torch Flame arrestor 6290-4 cutting nozzle Cutting lever Multipurpose wrench Heating nozzle Spark lighter Nozzle mixer Brass torch... -
Page 5: Preparation
Preparation These instructions are provided to offer our best advice and recommendations for the safe use of gas cylinder pressure regulators and other related products. All instructions are mere recommendations, and above all, the safe use of all equipment rests with the operator. ATENCIÓN CAUTION •... - Page 6 Preparation 7. Clean the inside of each hose by slowly opening the cylinder valve until it reaches 34.4 kPa (5 PSI) (0.34 bar). Allow gas to flow for 10 seconds to expel any residue from inside the hose, and then close the valve. Repeat the procedure with the other hose.
-
Page 7: Startup
Startup Ignition 1. Open the ACETYLENE valve on the torch approximately 1/2 turn. 2. Use the spark lighter to ignite the flame. 3. Turn the ACETYLENE valve on the torch until excess black smoke is eliminated. 4. Open the OXYGEN valve on the torch until a neutral flame appears (A). -
Page 8: Pressure Adjustment
Pressure adjustment CAUTION For best consumption and performance results, it is recommended to use the process pressures shown in the tables below. These pressures are a guide, as the operation's outcome may vary depending on the specific conditions of each process. OXY-ACETYLENE CUTTING NOZZLES OXYGEN pressure ACETYLENE pressure... -
Page 9: Cutting Operation
Cutting operation 1. Bring the flame close to the piece you are going to cut. 2. Place the tip of the preheating dart above the material. 3. Heat the material until it becomes "red hot." 4. Slowly press the oxygen lever to initiate the cut. 5. -
Page 10: Troubleshooting
• Use the nozzle cleaner to clean it. defined, uneven, or irregular. Inconsistent pressure in • The seal is defective. • Visit an authorized TRUPER service center to replace the regulator. the regulator. The cutting nozzle • The nozzle is loose. -
Page 11: Notes
Notes ENGLISH... - Page 12 For inquiries or assistance, please contact us at 800 0187873. Imported by: TRUPER, S.A. de C.V. Parque Industrial 1, Parque Industrial Jilotepec, Jilotepec, Edo. de Méx. C.P. 54257. Tel. 76 1782 9100. Made in China. WWW.TRUPER.COM 10-2023 ENGLISH...
Need help?
Do you have a question about the CORSOL-T and is the answer not in the manual?
Questions and answers